NPE405H Datasheet, PDF (10/70 Pages) Applied Micro Circuits Corporation – PowerNP NPe405H Embedded Processor

NPe405H – PowerNP NPe405H Embedded Processor
Revision 1.01 – April 18, 2007
Data Sheet
SDRAM MEMORY CONTROLLER
The NPe405H Memory Controller provides a low latency access path to SDRAM memory. The memory controller
supports four logical banks. Up to 256MB per bank are supported, for a maximum of 1GB total. Memory access
and refresh timing, address and bank sizes, and memory addressing modes are programmable.
Features include:
• 11x8 to 13x11 row-column address modes (2- and 4-bank devices supported)
• Memory bus operates at same frequency as PLB
• 32-bit memory interface support
• Programmable address range for each bank of memory
- 4GB address space
• Industry standard 168-pin DIMMS are supported (some configurations)
• 200 MHz NPe405H supports up to 100 MHz memory with PC100 support
• 266 MHz NPe405H supports up to 133 MHz memory with PC133 support
• 4MB to 256MB per bank
• Programmable timing
• Auto refresh
• Page Mode Accesses with up to 4 open pages
• Power Management (self-refresh)
• Error Checking and Correction (ECC) support
- Standard single error correct, double error detect coverage
- Aligned nibble error detect
- Address error logging
EXTERNAL BUS CONTROLLER (EBC)
• Supports eight ROM, EPROM, SRAM, Flash, and Slave Peripheral I/O banks supported
• Up to 66.66MHz operation
• Burst and non-burst devices
• 8-, 16-, 32-bit byte-addressable data bus width support
• Latch data on Ready, Synchronous or Asynchronous
• Programmable 2K clock-cycle time-out counter with disable for Ready
• Programmable access timing per device
- 0–255 wait states for non-bursting devices
- 0 –31 Burst Wait States for first access and up to 7 Wait States for subsequent accesses
- Programmable chip select assertion/negation relative to driving address bus
- Programmable output and write-enable assertion/negation relative to assertion of chip select
• Programmable address mapping
• Peripheral device wait via “Ready”
• External master interface
- Write posting from external master
- Read prefetching on PLB for external master reads
- Bursting capable from external master
- Allows external master access to all non-EBC PLB slaves
- External master can control EBC slaves for own access and control
10 DS2011
AMCC Proprietary