AK4646EZ Datasheet, PDF (7/78 Pages) Asahi Kasei Microsystems – Stereo CODEC with MIC/SPK-AMP

[AK4646EZ]
ABSOLUTE MAXIMUM RATINGS
(AVSS, DVSS, SVSS=0V; Note 3)
Parameter
Symbol
min
Power Supplies: Analog
AVDD
−0.3
Digital
DVDD
−0.3
Speaker-Amp
SVDD
−0.3
|AVSS – DVSS|
(Note 4)
ΔGND1
-
|AVSS – SVSS|
(Note 4)
ΔGND2
-
Input Current, Any Pin Except Supplies
IIN
-
Analog Input Voltage (Note 5)
VINA
−0.3
Digital Input Voltage (Note 6)
VIND
−0.3
Ambient Temperature
(Note 7)
Ta
−30
(powered applied)
(Note 8)
Ta
−30
Storage Temperature
Tstg
−65
Maximum Power Dissipation (Note 9)
Pd1
-
max
4.6
4.6
4.6
0.3
0.3
±10
AVDD+0.3
DVDD+0.3
85
70
150
450
Units
V
V
V
V
V
mA
V
V
°C
°C
°C
mW
Note 3. All voltages are with respect to ground.
Note 4. AVSS, DVSS and SVSS must be connected to the same analog ground plane.
Note 5.MIN, RIN2/IN2−, LIN2/IN2+, LIN1/IN1−, RIN1/IN1+ pins
Note 6. PDN, CSN, CCLK, CDTIO, SDTI, LRCK, BICK, MCKI pins
Pull-up resistors at SDA and SCL pins should be connected to DVDD or less voltage.
Note 7. In case that the exposed pad on the bottom surface of the package is connected to the ground.
Note 8. In case that the exposed pad on the bottom surface of the package is open.
Note 9. In case that PCB wiring density is 100%. This power is the AK4646 internal dissipation that does not include
power of externally connected speaker.
WARNING: Operation at or beyond these limits may result in permanent damage to the device.
Normal operation is not guaranteed at these extremes.
RECOMMENDED OPERATING CONDITIONS
(AVSS, DVSS, SVSS=0V; Note 3)
Parameter
Symbol
min
typ
Power Supplies Analog
AVDD
2.2
3.3
(Note 10) Digital
DVDD
1.6
3.3
SPK-Amp (Note 11)
SVDD
2.2
3.3
Difference
DVDD−AVDD
-
-
DVDD−SVDD
-
-
Max
Units
3.6
V
3.6
V
4.0
V
+0.3
V
+0.3
V
Note 3. All voltages are with respect to ground.
Note 10. The power-up sequence between AVDD, DVDD and SVDD is not critical. When AVDD or SVDD is powered
OFF, the power supply current of DVDD at power-down mode may be increased. When the power supplies are
partially powered OFF, the AK4646 must be reset by bringing PDN pin “L” after these power supplies are
powered ON again.
Note 11. SVDD = 2.2 ∼ 3.6V when 8Ω dynamic speaker is connected to the AK4646.
* AKEMD assumes no responsibility for the usage beyond the conditions in this datasheet.
MS0630-E-00
-7-
2007/06