W25Q256JVEIQ-TR Datasheet, PDF (50/92 Pages) Winbond – 3V 256M-BIT SERIAL FLASH MEMORY WITH DUAL/QUAD SPI

W25Q256JV
8.2.22 Set Burst with Wrap (77h)
The Set Burst with Wrap (77h) instruction is used in conjunction with “Fast Read Quad I/O” and “Word
Read Quad I/O” instructions to access a fixed length of 8/16/32/64-byte section within a 256-byte page.
Certain applications can benefit from this feature and improve the overall system code execution
performance.
Similar to a Quad I/O instruction, the Set Burst with Wrap instruction is initiated by driving the /CS pin low
and then shifting the instruction code “77h” followed by 24/32 dummy bits and 8 “Wrap Bits”, W7-0. The
instruction sequence is shown in Figure 28. Wrap bit W7 and the lower nibble W3-0 are not used.
W6, W5
00
01
10
11
W4 = 0
Wrap Around
Wrap Length
Yes
8-byte
Yes
16-byte
Yes
32-byte
Yes
64-byte
W4 =1 (DEFAULT)
Wrap Around Wrap Length
No
N/A
No
N/A
No
N/A
No
N/A
Once W6-4 is set by a Set Burst with Wrap instruction, all the following “Fast Read Quad I/O” instructions
will use the W6-4 setting to access the 8/16/32/64-byte section within any page. To exit the “Wrap Around”
function and return to normal read operation, another Set Burst with Wrap instruction should be issued to
set W4 = 1. The default value of W4 upon power on or after a software/hardware reset is 1.
/CS
CLK
Mode 3
Mode 0
IO₀
IO₁
IO₂
IO₃
0 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 Mode 3
Instruction (77h)
don't
care
don't
care
don't
care
Wrap Bit
Mode 0
X X X X X X w4 X
X X X X X X w5 X
X X X X X X w6 X
XXXXXXXX
Figure 28. Set Burst with Wrap Instruction
32-Bit dummy bits are required when the device is operating in 4-Byte Address Mode
- 49 -