|
THS8200-EP Datasheet, PDF (67/104 Pages) Texas Instruments – All-Format Oversampled Component Video/PC Graphics D/A System With Three 11-Bit DACs, CGMS Data Insertion | |||
|
◁ |
THS8200-EP
www.ti.com
SLES253 â DECEMBER 2009
0 : DLL used for clock generation; normal operation with internally generated 2Ã clock. This mode
should be selected for most video formats when a 1Ã clock is available on the device clock input,
and either 1Ã or 2Ã DAC operation is desired internally (as selected by register data_ifir35_bypass)
1 : DLL bypassed for clock generation. In this case the clock input on the CLKIN pin is used directly
as the 2Ã clock, rather than the internally generated signal from the DLL. This mode is meant for test
purposes only.
vesa_colorbars:
Color bar test pattern
{chip_ctl 0x03(5)}
[0]
0 : normal operation
1 : Device generates color bar pattern; external video inputs are ignored. The color bar pattern is
only supported in VESA PC graphics mode, with the device configured in master mode
(chip_ms = 1).
dll_freq_sel:
dll_freq_sel:
{chip_ctl 0x03(4)}
[0]
Sets a frequency range for the DLL 2Ã clock generation. The DLL should not be used at >80 MHz. In
this case the vesa_clk register should be enabled. As a consequence, 2Ã video interpolation is not
available for formats with >80 MHz pixel clock.
0 : high frequency range: pixel clock from 40â80 MHz
1 : low frequency range: pixel clock from 10â40 MHz
dac_pwdn:
dac_pwdn:
{chip_ctl 0x03(3)}
[0]
0 : normal operation
1 : DACs go into power-down state.
chip_pwdn:
Chip power down
{chip_ctl 0x03(2)}
[0]
0 : normal operation
1 : power down of all digital logic except I2C
chip_ms:
Chip mode select
{chip_ctl 0x03(1)}
[0]
0 : slave mode. Device synchronizes to incoming video sync signals, either embedded in
ITU-R.BT656 interface or received from dedicated timing signals.
1 : master mode. Device requests video data and generates video input timing signals to external
(memory) device, according to the programmed frame/field format. Master mode is only available
when the DTG is operating in VESA mode (PC graphics signals).
arst_func_n:
Chip software reset
{chip_ctl 0x03(0)}
[1]
0 : functional block goes into reset state. I2C registers retain values.
Note: the user needs to issue a software reset after input video is disconnected from the input bus
and reconnected (e.g. after a video format change), in order to synchronize the internal display
timing generator to the input video source properly.
1 : normal operation
Copyright © 2009, Texas Instruments Incorporated
Submit Documentation Feedback
Product Folder Link(s): THS8200-EP
I2C Register Map
67
|
▷ |