LP3918 Datasheet, PDF (24/39 Pages) National Semiconductor (TI) – Battery Charge Management and Regulator Unit

LP3918
SNVS476D – AUGUST 2007 – REVISED MAY 2013
Prequalification to Fast
Charge transition
1.0 C
V_TERM
V_RSTRT
3.0V
Transition to Constant
Voltage-mode
Charging current
Maintenance charging
starts
Charging current
www.ti.com
50 mA
EOC
Time
Figure 11. Charge Cycle Diagram
Further Charger Register Information
Charger Control Register 1
Table 14. Register Address 8h'10: CHGCNTL1
BIT
NAME
FUNCTION (if bit = '1')
7
USB_MODE
Sets the Current Level in USB mode.
_EN
6
CHG_MODE
Forces the charger into USB mode when active high.
_EN
If low, charger is in normal charge mode.
5
FORCE
Forces an EOC event.
_EOC
4
TOUT_
Doubles the timeout delays for all timeout signals.
Doubling
3
EN_Tout
Enables the timeout counters. When set to '0' the timeout counters
are disabled.
2
EN_EOC
Enables the End of Charge current level threshold detection.
When set to '0' the functions are disabled.
1
Set_
Forces the charger into LDO mode. Function available on
LDOmode
LP3918TL_L.
0
EN_CHG
Charger enable.
Charger Status Register 1 Read only
Table 15. Register Address 8h'13: CHGSTATUS1
BIT
NAME
FUNCTION (if bit = '1')
7
BAT_OVER
Is set when battery voltage exceeds 4.7V.
_OUT
6
CHGIN_
Is set when a valid input voltage is detected at CHG_IN pin.
OK_Out
5
EOC
Is set when the charging current decreases below the
programmed End Of Charge levlel.
4
Tout_
Set after timeout on full rate charge.
Fullrate
3
Tout_
Set after timeout for precharge mode.
Precharge
2
LDO_Mode
Only available on LP3918TL_L.
24
Submit Documentation Feedback
Product Folder Links: LP3918
Copyright © 2007–2013, Texas Instruments Incorporated