CC430F6147_15 Datasheet, PDF (19/118 Pages) Texas Instruments – MSP430 SoC With RF Core

www.ti.com
ECCN 5E002 TSPA - Technology / Software Publicly Available
CC430F614x
CC430F514x
CC430F512x
SLAS555A – NOVEMBER 2012 – REVISED FEBRUARY 2013
Bootstrap Loader (BSL)
The BSL enables users to program the flash memory or RAM using various serial interfaces. Access to the
device memory via the BSL is protected by an user-defined password. BSL entry requires a specific entry
sequence on the RST/NMI/SBWTDIO and TEST/SBWTCK pins. For a complete description of the features of the
BSL and its implementation, see the MSP430 Programming Via the Bootstrap Loader User's Guide (SLAU319).
Table 7. UART BSL Pin Requirements and Functions
DEVICE SIGNAL
RST/NMI/SBWTDIO
TEST/SBWTCK
P1.6
P1.5
VCC
VSS
BSL FUNCTION
Entry sequence signal
Entry sequence signal
Data transmit
Data receive
Power supply
Ground supply
JTAG Operation
JTAG Standard Interface
The CC430 family supports the standard JTAG interface which requires four signals for sending and receiving
data. The JTAG signals are shared with general-purpose I/O. The TEST/SBWTCK pin is used to enable the
JTAG signals. In addition to these signals, the RST/NMI/SBWTDIO is required to interface with MSP430
development tools and device programmers. The JTAG pin requirements are shown in Table 8. For further
details on interfacing to development tools and device programmers, see the MSP430 Hardware Tools User's
Guide (SLAU278). For a complete description of the features of the JTAG interface and its implementation, see
MSP430 Programming Via the JTAG Interface (SLAU320).
Table 8. JTAG Pin Requirements and Functions
DEVICE SIGNAL
PJ.3/TCK
PJ.2/TMS
PJ.1/TDI/TCLK
PJ.0/TDO
TEST/SBWTCK
RST/NMI/SBWTDIO
VCC
VSS
DIRECTION
IN
IN
IN
OUT
IN
IN
FUNCTION
JTAG clock input
JTAG state control
JTAG data input, TCLK input
JTAG data output
Enable JTAG pins
External reset
Power supply
Ground supply
Spy-Bi-Wire Interface
In addition to the standard JTAG interface, the CC430 family supports the two wire Spy-Bi-Wire interface. Spy-Bi-
Wire can be used to interface with MSP430 development tools and device programmers. The Spy-Bi-Wire
interface pin requirements are shown in Table 9. For further details on interfacing to development tools and
device programmers, see the MSP430 Hardware Tools User's Guide (SLAU278). For a complete description of
the features of the JTAG interface and its implementation, see MSP430 Programming Via the JTAG Interface
(SLAU320).
Table 9. Spy-Bi-Wire Pin Requirements and Functions
DEVICE SIGNAL
TEST/SBWTCK
RST/NMI/SBWTDIO
VCC
VSS
DIRECTION
IN
IN, OUT
FUNCTION
Spy-Bi-Wire clock input
Spy-Bi-Wire data input/output
Power supply
Ground supply
Copyright © 2012–2013, Texas Instruments Incorporated
Submit Documentation Feedback
19