EFM8SB1 Datasheet, PDF (2/55 Pages) Silicon Laboratories – The EFM8SB1 highlighted features are listed below

EFM8SB1 Data Sheet
Feature List
1. Feature List
The EFM8SB1 highlighted features are listed below.
• Core:
• Pipelined CIP-51 Core
• Fully compatible with standard 8051 instruction set
• 70% of instructions execute in 1-2 clock cycles
• 25 MHz maximum operating frequency
• Memory:
• Up to 8 kB flash memory, in-system re-programmable
from firmware.
• Up to 512 bytes RAM (including 256 bytes standard 8051
RAM and 256 bytes on-chip XRAM)
• Power:
• Internal LDO regulator for CPU core voltage
• Power-on reset circuit and brownout detectors
• I/O: Up to 17 total multifunction I/O pins:
• Flexible peripheral crossbar for peripheral routing
• 5 mA source, 12.5 mA sink allows direct drive of LEDs
• Clock Sources:
• Internal 20 MHz low power oscillator with ±10% accuracy
• Internal 24.5 MHz precision oscillator with ±2% accuracy
• Internal 16.4 kHz low-frequency oscillator or RTC 32 kHz
crystal (RTC crystal not available on CSP16 packages)
• External crystal, RC, C, and CMOS clock options
• Timers/Counters and PWM:
• 32-bit Real Time Clock (RTC)
• 3-channel Programmable Counter Array (PCA) supporting
PWM, capture/compare, and frequency output modes with
watchdog timer function
• 4 x 16-bit general-purpose timers
• Communications and Digital Peripherals:
• UART
• SPI™ Master / Slave
• SMBus™ / I2C™ Master / Slave
• 16-bit CRC unit, supporting automatic CRC of flash at 256-
byte boundaries
• Analog:
• Capacitive Sense (CS0)
• Programmable current reference (IREF0)
• 12-Bit Analog-to-Digital Converter (ADC0)
• 1 x Low-current analog comparator
• On-Chip, Non-Intrusive Debugging
• Full memory and register inspection
• Four hardware breakpoints, single-stepping
• Pre-loaded UART bootloader
• Temperature range -40 to 85 ºC
• Single power supply 1.8 to 3.6 V
• QSOP24, QFN24, QFN20, and CSP16 packages
With on-chip power-on reset, voltage supply monitor, watchdog timer, and clock oscillator, the EFM8SB1 devices are truly standalone
system-on-a-chip solutions. The flash memory is reprogrammable in-circuit, providing non-volatile data storage and allowing field up-
grades of the firmware. The on-chip debugging interface (C2) allows non-intrusive (uses no on-chip resources), full speed, in-circuit
debugging using the production MCU installed in the final application. This debug logic supports inspection and modification of memory
and registers, setting breakpoints, single stepping, and run and halt commands. All analog and digital peripherals are fully functional
while debugging. Each device is specified for 1.8 to 3.6 V operation and is available in 16-pin CSP, 20-pin QFN, 24-pin QFN, or 24-pin
QSOP packages. All package options are lead-free and RoHS compliant.
Note: CSP devices can be handled and soldered using industry standard surface mount assembly techniques. However, because CSP
devices are essentially a piece of silicon and are not encapsulated in plastic, they are susceptible to mechanical damage and may be
sensitive to light. When CSP packages must be used in an environment exposed to light, it may be necessary to cover the top and
sides with an opaque material.
silabs.com | Smart. Connected. Energy-friendly.
Rev. 1.2 | 1