RX220_15 Datasheet, PDF (9/107 Pages) Renesas Technology Corp – Renesas MCUs

RX220 Group
1. Overview
1.4 Pin Functions
Table 1.4 lists the pin functions.
Table 1.4
Pin Functions (1 / 3)
Classifications
Pin Name
Power supply
VCC
VCL
I/O
Input
—
Clock
Operating mode
control
System control
VSS
XTAL
EXTAL
XCIN
XCOUT
MD
RES#
Input
Output
Input
Input
Output
Input
Input
CAC
On-chip emulator
Interrupt
Multi-function timer
pulse unit
CACREF
FINED
NMI
IRQ0 to IRQ7
MTIOC0A, MTIOC0B
MTIOC0C, MTIOC0D
MTIOC1A, MTIOC1B
Input
I/O
Input
Input
I/O
I/O
MTIOC2A, MTIOC2B
I/O
MTIOC3A, MTIOC3B
MTIOC3C, MTIOC3D
MTIOC4A, MTIOC4B
MTIOC4C, MTIOC4D
MTIC5U, MTIC5V, MTIC5W
I/O
I/O
Input
Port output enable
MTCLKA, MTCLKB,
MTCLKC, MTCLKD
POE0# to POE3#, POE8#
Input
Input
8-bit timer
Realtime clock
TMO0 to TMO3
TMCI0 to TMCI3
TMRI0 to TMRI3
RTCOUT
Output
Input
Input
Output
Description
Power supply pin. Connect it to the system power supply.
Connect this pin to the VSS pin via the 0.1 μF smoothing capacitor
used to stabilize the internal power supply. Place the capacitor close
to the pin.
Ground pin. Connect it to the system power supply (0 V).
Pins for connecting a crystal resonator. An external clock signal can
be input through the EXTAL pin.
Input/output pins for the sub-clock generation circuit. Connect a
crystal resonator between XCIN and XCOUT.
Pin for setting the operating mode. The signal levels on this pin
must not be changed during operation.
Reset signal input pin. This LSI enters the reset state when this
signal goes low.
Input pin for the measuring circuit for clock frequency precision.
FINE interface pin.
Non-maskable interrupt request pin.
Interrupt request pins.
The TGRA0 to TGRD0 input capture input/output compare output/
PWM output pins.
The TGRA1 and TGRB1 input capture input/output compare output/
PWM output pins.
The TGRA2 and TGRB2 input capture input/output compare output/
PWM output pins.
The TGRA3 to TGRD3 input capture input/output compare output/
PWM output pins.
The TGRA4 to TGRD4 input capture input/output compare output/
PWM output pins.
The TGRU5, TGRV5, and TGRW5 input capture input/external
pulse input pins.
Input pins for external clock.
Input pins for request signals to place the MTU pins in the high
impedance state.
Compare match output pins.
Input pins for external clocks to be input to the counter.
Input pins for the counter reset.
Output pin for 1-Hz clock.
R01DS0130EJ0110 Rev.1.10
Dec 20, 2013
Page 9 of 105