38K0 Datasheet, PDF (132/133 Pages) Mitsubishi Electric Semiconductor – SINGLE-CHIP 8-BIT CMOS MICROCOMPUTER

REVISION HISTORY
38K0 GROUP DATA SHEET
Rev.
2.1
3.0
Date
10/09/02
10/05/06
Description
Page
Summary
P. 111 --
Electrical characteristics of Standard and L version are indicated respectively (Those
of L version are indicated from page 119).
Table
17 to Tbale 21: Tytle: Vcc=3.00 to 5.25 V →Vcc=4.00 to 5.25 V, Vcc when system
clock 6MHz is deleted, 2,4-divide mode when system clock 12MHz is deleted.
P. 111
Table 7: Vcc when system clock 8MHz→Vcc when system clock ≤ 8MHz
USBVREF is deleted.
P. 112
Table 18:Vcc conditions of f(XIN), f(XIN) or f(SYN), and f(φ) are deleted. Data when
Vcc=3.00 to 4.00 V is deleted. Notes 4 is revised.
P. 113 Table 19: Indications of Vcc and VccE in Test conditions are deleted. Data when
VI=VSS in IIL pull-up is deleted.
P. 114 Table 20: Ranges of Vcc in Test conditions are deleted. Data when Vcc= 3.00 to
4.00 V is deleted. Typ. in normal mode are revised.
P. 116 Timing requirements table when Vcc= 3.00 to 4.00 V is deleted.
Table 23 is added.
P. 117 Switching characteristics table when Vcc= 3.00 to 4.00 V is deleted.
Table 25 is added.
P. 118 Table 26: Tytle: Vcc=3.00 to 5.25 V→Vcc 4.00 to 5.25V
P. 119 -- Electrical characteristics and switching characteristics of L version are added.
P. 131 -- Timing chart (2) to (6) are added.
All pages Package names “64P6U-A” → “PLQP0064GA-A” revised
Package names “64P6Q-A” → “PLQP0064KB-A” revised
P. 78
P. 79
CLOCK GENERATING CIRCUIT; “No external resistor is needed .... resistor
exists on-chip.” → “No external resistor is needed .... depending on conditions.)
Fig. 111; Pulled up added, NOTE added
P. 109 NOTES ON USAGE; Power Source Voltage, USB Communication added
P. 136,137 PACKAGE OUTLINE revised
(3/3)