M16C63 Datasheet, PDF (106/115 Pages) Renesas Technology Corp – RENESAS MCU

M16C/63 Group
5. Electrical Characteristics
V_CC1 = V_CC2 = 1.8 V
Table 5.63 Electrical Characteristics (3)
V_CC1 = V_CC2 = 1.8 to 2.7 V, V_SS = 0 V at T_opr = −20 to 85°C/−40 to 85°C, f_(BCLK) = 5 MHz unless otherwise
specified.
Symbol
Parameter
Measuring Condition
I_CC
Power supply current High-speed mode f_(BCLK) = 5 MHz (no division)
XIN = 5 MHz (square wave),
In single-chip, mode,
125 kHz on-chip oscillator stop
the output pin are
CM15 = 1 (drive capacity High)
open and other pins
A/D converter stop
are V_SS
f_(BCLK) = 5 MHz (no division),
XIN = 5 MHz (square wave)
125 kHz on-chip oscillator stop
CM15 = 1 (drive capacity High)
A/D converter operating ⁽²⁾
f_(BCLK) = 5 MHz
XIN = 5 MHz (square wave)
125 kHz on-chip oscillator stop
CM15 = 0 (drive capacity Low)
A/D converter stop
f_(BCLK) = 5 MHz (no division)
XIN = 5 MHz (square wave)
125 kHz on-chip oscillator stop
CM15 = 1 (drive capacity High)
PCLKSTP1 = FF (peripheral clock stop)
f_(BCLK) = 5 MHz (no division)
XIN = 5 MHz (square wave)
125 kHz on-chip oscillator stop
CM15 = 0 (drive capacity Low)
PCLKSTP1 = FF (peripheral clock stop)
40 MHz on-chip Main clock stop
oscillator mode 40 MHz on-chip oscillator on,
divide-by-8 (f_(BCLK) = 5 MHz)
125 kHz on-chip oscillator stop
125 kHz on-chip Main clock stop
oscillator mode 40 MHz on-chip oscillator stop
125 kHz on-chip oscillator on, no division
FMR22 = 1 (slow read mode)
Low-power mode f_(BCLK) = 32 MHz
FMR 22 = FMR23 = 1 (in low-current
consumption read mode)
on flash memory ⁽¹⁾
Wait mode
f(BCLK) = 32 kHz
Main clock stop
40 MHz on-chip oscillator stop
125 kHz on-chip oscillator on
PM25 = 1 (peripheral function clock fC
operating)
T_opr = 25°C
Real-time clock operating
f_(BCLK) = 32 MHz
Main clock stop
40 MHz on-chip oscillator stop
125 kHz on-chip oscillator stop
PM25 = 0 (peripheral function clock fC stop)
T_opr = 25°C
Stop mode
T_opr = 25°C
Standard
Unit
Min. Typ. Max.
2.6
mA
3.3
mA
2.6
mA
2.2
mA
2.2
mA
2.8
mA
450.0
μA
80.0
μA
5.3
μA
5.0
μA
2.2
μA
Notes:
1. This indicates the memory in which the program to be executed exists
2. A/D conversion is executed in repeat mode.
REJ03B0271-0100 Rev.1.00 Sep 15, 2009
Page 106 of 113