HYB18M1G16 Datasheet, PDF (17/65 Pages) Qimonda AG – 1-Gbit x16 DDR Mobile-RAM

Data Sheet
2.4
Commands
HY[B/E]18M1G16[0/1]BF
1-Gbit DDR Mobile-RAM
TABLE 6
Command Overview
Command
CS RAS CAS WE Address Note
NOP DESELECT
HXXXX
1)2)
NO OPERATION
L
H
H
H
X
1)2)
ACT ACTIVE (Select bank and row)
L
L
H
H
Bank / Row ¹⁾³⁾
RD READ (Select bank and column and start read burst)
L
HL
H
Bank / Col ¹⁾⁴⁾
WR WRITE (Select bank and column and start write burst)
L
HL
L
Bank / Col ¹⁾⁴⁾
BST BURST TERMINATE or DEEP POWER-DOWN
L
H
H
L
X
1)5)
PRE PRECHARGE (Deactivate row in bank or banks)
L
L
H
L
Code
1)6)
ARF AUTO REFRESH or SELF REFRESH entry
L
L
L
H
X
1)7)8)
MRS MODE REGISTER SET
L
L
L
L
Op-Code
1)9)
1) CKE is HIGH for all commands shown except SELF REFRESH and DEEP POWER DOWN.
2) DESELECT and NOP are functionally interchangeable.
3) BA0, BA1 provide the bank address, and A0 - A12 provide the row address.
4) BA0, BA1 provide the bank address, A0 - A9 provide the column address; A10 HIGH enables the Auto Precharge feature (non persistent),
A10 LOW disables the Auto Precharge feature.
5) This command is BURST TERMINATE if CKE is HIGH, DEEP POWER-DOWN if CKE is LOW. The BURST TERMINATE command is
defined for READ bursts with Auto Precharge disabled only; it is undefined (and should not be used) for read bursts with Auto Precharge
enabled, and for write bursts.
6) A10 LOW: BA0, BA1 determine which bank is precharged.A10 HIGH: all banks are precharged and BA0, BA1 are “Don’t Care”.
7) This command is AUTO REFRESH if CKE is HIGH, SELF REFRESH if CKE is LOW.
8) Internal refresh counter controls row and bank addressing; all inputs and I/Os are “Don’t Care” except for CKE.
9) BA0, BA1 select either the Mode Register (BA0 = 0, BA1 = 0) or the Extended Mode Register (BA0 = 0, BA1 = 1); other combinations of
BA0, BA1 are reserved; A0 - A12 provide the op-code to be written to the selected mode register.
Name (Function)
Write Enable
Write Inhibit
1) Used to mask write data provided coincident with the corresponding data
DM
L
H
TABLE 7
DM Operation
DQs Note
Valid ¹⁾
X
1)
Address (BA0, BA1, A0 - A12) and command inputs (CKE, CS, RAS, CAS, WE) are all registered on the crossing of the positive
edge of CK and the negative edge of CK. Figure 6 shows the basic timing parameters, which apply to all commands and
operations.
Rev.1.0, 2007-03
17
10242006-Y557-TZXW