SDA9415-B13 Datasheet, PDF (99/185 Pages) Micronas – Display Processor and Scan Rate Converter

SDA 9415 - B13
Preliminary Data Sheet
Film mode IV: ADOPMOM=111
MOVMO
x
0
1
1
x
MOVPH
x
x
0
1
x
MOVTYP
x
x
x
x
x
VTSEQM
0
0
0
0
1
GMOTION
0
1
1
1
x
STOPMOMint
Frame repetition,
ABAB, 0011
STOPMOM
VDU, film mode,
phase 0, PAL,
0001
VDU, film mode,
phase 1, PAL,
0010
Simple 50, 0101
STOPMOSint
STOPMOS
STOPMOS
STOPMOS
STOPMOS
Line doubling, AB,
010
Table 76 Adaptive operation modes
Example for explanation of the adaptive operation modes:
ADOPMOM = 4: Film mode I, RMODE=0
In this case the scan rate conversion algorithm is controlled by the signal MOVMO,
MOVTYP and MOVPH. If MOVMO is equal 0 the scan rate conversion mode is defined
by STOPMOM and STOPMOS (e.g. Micronas VDU). If MOVMO is equal 1 and MOVTYP
is equal 0 the scan rate conversion algorithm is changed depending on the MOVPH
signal to Micronas VDU, Film mode, PAL, phase 0 or 1. If MOVMO is equal 1 and
MOVTYP is equal 1 the scan rate conversion algorithm is changed depending on the
MOVPH signal to Micronas VDU, Film mode, NTSC, phase 0 or 1. In case of film mode
PAL, the MOVPH signal is constant for the applied material. In case of Film mode NTSC,
the MOVPH signal changes each 2^th or 3^th field, respectively.
I²C Bus
parameter
STOPMOM
STOPMOS
ADOPMOM
Sub address
48h
4Ah
49h
Description
STatic OPeration MOdes Master
STatic OPeration MOdes Slave
ADaptive OPeration MOdes Master
Table 77 Output write I²C Bus parameter
99
Micronas