SDA9415-B13 Datasheet, PDF (122/185 Pages) Micronas – Display Processor and Scan Rate Converter

SDA 9415 - B13
Preliminary Data Sheet
I²C Bus
parameter
COARSDEL
Sub address
5Ch
Description
Delay of the luminance signal in relation to the chrominance signal
in 2*CLKD clocks
Table 101 Output write I²C Bus parameter
5.12.7 Digital-to-Analog conversion
Three 9-bit Digital-to-Analog converters are implemented. The DACs are short-circuit
protected converters with current outputs. The full range output current of the IY_O,
IU_O, IV_O channels (I_OFR) is determined by the current I_REF at the pin RREF_I by I_OFR
~ 10 I_REF . The voltage at the pin RREF_I is generated via pin UREF_I by an internal
operational amplifier and follows the voltage at the pin UREF_I. Thus I_REF is given by I_REF
~ V_UREF/R_REF where R_REF is a resistor between RREF_I and analog ground. Another way
to define I_REF is the application of a current sink at the RREF_I point. For recommended
values of V_UREF and I_REF compare "Operating range" on page 177. For applications
with lower requirements there is still another way to define I_OFR: Connect pin UREF_I to
the positive supply and apply a resistor against ground. Since in this operation mode the
internal reference amplifier reaches saturation, the exact value of I_REF is not exactly
predictable.
I²C Bus
parameter
CHROM_AMP
Sub address
5Eh
Description
Chrominance amplification factor adjustment for DAC output
1: amplification factor 2
0: amplification factor 1
Table 102 Output write I²C Bus parameter
122
Micronas