PIC18F2455_07 Datasheet, PDF (375/430 Pages) Microchip Technology – 28/40/44-Pin, High Performance, Enhanced Flash, USB Microcontrollers with nanoWatt Technology

PIC18F2455/2550/4455/4550
28.3 DC Characteristics: PIC18F2455/2550/4455/4550 (Industrial)
PIC18LF2455/2550/4455/4550 (Industrial) (Continued)
DC CHARACTERISTICS
Standard Operating Conditions (unless otherwise stated)
Operating temperature -40°C ≤ TA ≤ +85°C for industrial
Param
No.
Symbol
Characteristic
Min
Max Units
Conditions
VOL Output Low Voltage
D080
I/O ports (except RC4/RC5 in
USB mode)
—
0.6
V IOL = 8.5 mA, VDD = 4.5V,
-40°C to +85°C
D083
OSC2/CLKO
(EC, ECIO modes)
—
0.6
V IOL = 1.6 mA, VDD = 4.5V,
-40°C to +85°C
VOLU D+/D- out
—
0.3
VDD = 4.35V,
USB suspended⁽⁵⁾
VOH Output High Voltage⁽³⁾
D090
I/O ports (except RC4/RC5 in
USB mode)
VDD – 0.7
—
V IOH = -3.0 mA, VDD = 4.5V,
-40°C to +85°C
D092
OSC2/CLKO
(EC, ECIO, ECPIO modes)
VDD – 0.7
—
V IOH = -1.3 mA, VDD = 4.5V,
-40°C to +85°C
VOHU D+/D- out
2.8
3.6
V VDD = 4.35V,
USB suspended⁽⁵⁾
Capacitive Loading Specs
on Output Pins
D100^{(4) COSC2 OSC2 pin}
—
15
pF In XT and HS modes
when external clock is
used to drive OSC1
D101 CIO
D102 CB
All I/O pins and OSC2
(in RC mode)
SCL, SDA
—
50
pF To meet the AC Timing
Specifications
—
400
pF I²C™ Specification
Note 1: In RC oscillator configuration, the OSC1/CLKI pin is a Schmitt Trigger input. It is not recommended that the
PIC^® device be driven with an external clock while in RC mode.
2: The leakage current on the MCLR pin is strongly dependent on the applied voltage level. The specified
levels represent normal operating conditions. Higher leakage current may be measured at different input
voltages.
3: Negative current is defined as current sourced by the pin.
4: Parameter is characterized but not tested.
5: D+ parameters per USB Specification 2.0.
© 2007 Microchip Technology Inc.
Preliminary
DS39632D-page 373