PIC18LF2XK22 Datasheet, PDF (26/42 Pages) Microchip Technology – Flash Memory Programming Specification

PIC18(L)F2XK22/4XK22
4.3 Verify Configuration Bits
A configuration address may be read and output on
PGD via the 4-bit command, ‘1001’. Configuration data
is read and written in a byte-wise fashion, so it is not
necessary to merge two bytes into a word prior to a
compare. The result may then be immediately
compared to the appropriate configuration data in the
programmer’s memory for verification. Refer to
Section 4.1 “Read Code Memory, ID Locations and
Configuration Bits” for implementation details of
reading configuration data.
4.4 Read Data EEPROM Memory
Data EEPROM is accessed one byte at a time via an
Address Pointer (register pair EEADRH:EEADR) and a
data latch (EEDATA). Data EEPROM is read by loading
EEADRH:EEADR with the desired memory location
and initiating a memory read by appropriately configur-
ing the EECON1 register. The data will be loaded into
EEDATA, where it may be serially output on PGD via
the 4-bit command, ‘0010’ (Shift Out Data Holding
register). A delay of P6 must be introduced after the
falling edge of the 8th PGC of the operand to allow
PGD to transition from an input to an output. During this
time, PGC must be held low (see Figure 4-4).
The command sequence to read a single byte of data
is shown in Table 4-2.
FIGURE 4-3:
READ DATA EEPROM
FLOW
Start
Set
Address
Read
Byte
Move to TABLAT
Shift Out Data
No
done?
Yes
Done
TABLE 4-2: READ DATA EEPROM MEMORY
4-bit
Command
Data Payload
Step 1: Direct access to data EEPROM.
0000
0000
9E A6
9C A6
BCF EECON1, EEPGD
BCF EECON1, CFGS
Step 2: Set the data EEPROM Address Pointer.
0000
0000
0000
0000
0E <Addr>
6E A9
OE <AddrH>
6E AA
MOVLW
MOVWF
MOVLW
MOVWF
<Addr>
EEADR
<AddrH>
EEADRH
Step 3: Initiate a memory read.
0000
80 A6
BSF EECON1, RD
Step 4: Load data into the Serial Data Holding register.
0000
0000
0000
0010
50 A8
6E F5
00 00
<MSB><LSB>
MOVF EEDATA, W, 0
MOVWF TABLAT
NOP
Shift Out Data⁽¹⁾
Note 1: The <LSB> is undefined. The <MSB> is the data.
Core Instruction
DS41398B-page 26
Advance Information
 2010 Microchip Technology Inc.