HYB25D128160CT Datasheet, PDF (8/85 Pages) Infineon Technologies AG – 128 Mbit Double Data Rate SDRAM

128 Mbit Double Data Rate SDRAM
DDR SDRAM
HYB25D128[400/800/160]C[C/E/T](L)
1
Overview
1.1
Features
• Double data rate architecture: two data transfers per clock cycle
• Bidirectional data strobe (DQS) is transmitted and received with data, to be used in capturing data at the
receiver
• DQS is edge-aligned with data for reads and is center-aligned with data for writes
• Differential clock inputs
• Four internal banks for concurrent operation
• Data mask (DM) for write data
• DLL aligns DQ and DQS transitions with CK transitions
• Commands entered on each positive CK edge; data and data mask referenced to both edges of DQS
• Burst Lengths: 2, 4, or 8
• CAS Latency: 2, 2.5, 3
• Auto Precharge option for each burst access
• Auto Refresh and Self Refresh Modes
• 7.8 µs Maximum Average Periodic Refresh Interval
• 2.5 V (SSTL_2 compatible) I/O
• V_DDQ = 2.5 V ± 0.2 V (DDR266A, DDR333); V_DDQ = 2.6 V ± 0.1 V (DDR400)
• V_DD = 2.5 V ± 0.2 V (DDR266, DDR333); V_DD = 2.6 V ± 0.1 V (DDR400)
• P-TFBGA-60-2 package with 3 depopulated rows (12 × 8 mm²)
• P-TSOPII-66-1 package
• Lead- and halogene-free = green product
1.2
Description
The 128 Mbit Double Data Rate SDRAM is a high-speed CMOS, dynamic random-access memory containing
268,435,456 bits. It is internally configured as a quad-bank DRAM.
The 128 Mbit Double Data Rate SDRAM uses a double-data-rate architecture to achieve high-speed operation.
The double data rate architecture is essentially a 2n prefetch architecture with an interface designed to transfer
two data words per clock cycle at the I/O pins. A single read or write access for the 128 Mbit Double Data Rate
SDRAM effectively consists of a single 2n-bit wide, one clock cycle data transfer at the internal DRAM core and
two corresponding n-bit wide, one-half-clock-cycle data transfers at the I/O pins.
A bidirectional data strobe (DQS) is transmitted externally, along with data, for use in data capture at the receiver.
DQS is a strobe transmitted by the DDR SDRAM during Reads and by the memory controller during Writes. DQS
is edge-aligned with data for Reads and center-aligned with data for Writes.
The 128 Mbit Double Data Rate SDRAM operates from a differential clock (CK and CK; the crossing of CK going
HIGH and CK going LOW is referred to as the positive edge of CK). Commands (address and control signals) are
registered at every positive edge of CK. Input data is registered on both edges of DQS, and output data is
referenced to both edges of DQS, as well as to both edges of CK.
Read and write accesses to the DDR SDRAM are burst oriented; accesses start at a selected location and
continue for a programmed number of locations in a programmed sequence. Accesses begin with the registration
of an Active command, which is then followed by a Read or Write command. The address bits registered
coincident with the Active command are used to select the bank and row to be accessed. The address bits
registered coincident with the Read or Write command are used to select the bank and the starting column location
for the burst access.
Data Sheet
8
Rev. 1.0, 2004-04