HYB25D128160CT Datasheet, PDF (24/85 Pages) Infineon Technologies AG – 128 Mbit Double Data Rate SDRAM

HYB25D128[400/800/160]C[C/E/T](L)
128 Mbit Double Data Rate SDRAM
Functional Description
3.3
Extended Mode Register
The Extended Mode Register controls functions beyond those controlled by the Mode Register; these additional
functions include DLL enable/disable, and output drive strength selection (optional). These functions are controlled
via the bits shown in the Extended Mode Register Definition. The Extended Mode Register is programmed via the
Mode Register Set command (with BA0 = 1 and BA1 = 0) and retains the stored information until it is programmed
again or the device loses power. The Extended Mode Register must be loaded when all banks are idle, and the
controller must wait the specified time before initiating any subsequent operation. Violating either of these
requirements result in unspecified operation.
EMR
Extended Mode Register Definition
(BA[1:0] = 01_B)
BA1 BA0 A11 A10 A9
A8
A7
A6
A5
A4
A3
A2
A1
A0
0
1
reg. addr
MODE
w
DS DLL
w
w
Field
Bits
DLL
0
DS
1
MODE [12:2]
1) w = write
Type¹⁾
w
w
w
Description
DLL Status
See Chapter 3.3.1.
0 Enabled
1 Disabled
Drive Strength
See Chapter 3.3.2, Chapter 4.1 and Chapter 4.2.
0 Normal
1 Weak
Operating Mode
Note: All other bit combinations are RESERVED.
00000000000Normal Operation
3.3.1 DLL Enable/Disable
The DLL must be enabled for normal operation. DLL enable is required during power up initialization, and upon
returning to normal operation after having disabled the DLL for the purpose of debug or evaluation. The DLL is
automatically disabled when entering self refresh operation and is automatically re-enabled upon exit of self
refresh operation. Any time the DLL is enabled, 200 clock cycles must occur before a Read command can be
issued. This is the reason 200 clock cycles must occur before issuing a Read or Write command upon exit of self
refresh operation.
3.3.2 Output Drive Strength
The normal drive strength for all outputs is specified to be SSTL_2, Class II. In addition this design version
supports a weak driver mode for lighter load and/or point-to-point environments which can be activated during
mode register set. I-V curves for the normal and weak drive strength are included in this document.
Data Sheet
24
Rev. 1.0, 2004-04