MC68908GZ8MFJE Datasheet, PDF (228/314 Pages) Freescale Semiconductor, Inc – Microcontrollers

System Integration Module (SIM)
16.7.1 Break Status Register
The break status register (BSR) contains a flag to indicate that a break caused an exit from wait mode.
This register is only used in emulation mode.
Address: $FE00
Bit 7
6
5
4
3
2
1
Bit 0
Read:
SBSW
R
Write:
R
R
R
R
R
Note⁽¹⁾
R
Reset: 0
0
0
0
0
0
0
0
R
= Reserved
1. Writing a logic 0 clears SBSW.
Figure 16-20. Break Status Register (BSR)
SBSW — SIM Break Stop/Wait
SBSW can be read within the break state SWI routine. The user can modify the return address on the
stack by subtracting one from it.
1 = Wait mode was exited by break interrupt.
0 = Wait mode was not exited by break interrupt.
16.7.2 SIM Reset Status Register
This register contains six flags that show the source of the last reset provided all previous reset status bits
have been cleared. Clear the SIM reset status register by reading it. A power-on reset sets the POR bit
and clears all other bits in the register.
Address: $FE01
Bit 7
6
5
4
3
2
1
Bit 0
Read: POR
PIN
COP
ILOP
ILAD MODRST LVI
0
Write:
Reset: 1
0
0
0
0
0
0
0
= Unimplemented
Figure 16-21. SIM Reset Status Register (SRSR)
POR — Power-On Reset Bit
1 = Last reset caused by POR circuit
0 = Read of SRSR
PIN — External Reset Bit
1 = Last reset caused by external reset pin (RST)
0 = POR or read of SRSR
COP — Computer Operating Properly Reset Bit
1 = Last reset caused by COP counter
0 = POR or read of SRSR
ILOP — Illegal Opcode Reset Bit
1 = Last reset caused by an illegal opcode
0 = POR or read of SRSR
MC68HC908GZ16 • MC68HC908GZ8 Data Sheet, Rev. 4
228
Freescale Semiconductor