MC68908GZ8MFJE Datasheet, PDF (132/314 Pages) Freescale Semiconductor, Inc – Microcontrollers

MSCAN08 Controller (MSCAN08)
MSCAN08 RUNNING
MCU
SLPRQ = 0
or MSCAN08
SLPAK = 0
MCU
MSCAN08 SLEEPING
SLPRQ = 1
SLPAK = 1
SLEEP REQUEST
SLPRQ = 1
SLPAK = 0
MSCAN08
Figure 12-7. Sleep Request/Acknowledge Cycle
After wakeup, the MSCAN08 waits for 11 consecutive recessive bits to synchronize to the bus. As a
consequence, if the MSCAN08 is woken-up by a CAN frame, this frame is not received. The receive
message buffers (RxFG and RxBG) contain messages if they were received before sleep mode was
entered. All pending actions are executed upon wakeup: copying of RxBG into RxFG, message aborts
and message transmissions. If the MSCAN08 is still in bus-off state after sleep mode was left, it continues
counting the 128*11 consecutive recessive bits.
12.8.2 MSCAN08 Soft Reset Mode
In soft reset mode, the MSCAN08 is stopped. Registers can still be accessed. This mode is used to
initialize the module configuration, bit timing and the CAN message filter. See 12.13.1 MSCAN08 Module
Control Register 0 for a complete description of the soft reset mode.
When setting the SFTRES bit, the MSCAN08 immediately stops all ongoing transmissions and
receptions, potentially causing CAN protocol violations.
NOTE
The user is responsible to take care that the MSCAN08 is not active when
soft reset mode is entered. The recommended procedure is to bring the
MSCAN08 into sleep mode before the SFTRES bit is set.
12.8.3 MSCAN08 Power-Down Mode
The MSCAN08 is in power-down mode when the CPU is in stop mode.
When entering the power-down mode, the MSCAN08 immediately stops all ongoing transmissions and
receptions, potentially causing CAN protocol violations.
NOTE
The user is responsible to take care that the MSCAN08 is not active when
power-down mode is entered. The recommended procedure is to bring the
MSCAN08 into sleep mode before the STOP instruction is executed.
MC68HC908GZ16 • MC68HC908GZ8 Data Sheet, Rev. 4
132
Freescale Semiconductor