SAP5SD-A-G1-T Datasheet, PDF (10/63 Pages) List of Unclassifed Manufacturers – Universal Actuator-Sensor Interface IC

SAP5S / SAP51
Universal Actuator-Sensor Interface IC
1.2. Operating Conditions
Table 2: Operating Conditions
Symbol Parameter
Min
Max. Unit
Note
V_LTGN
V_LTGP
I_LTGP
Negative supply voltage
DC voltage at LTGP relating to V_LTGN
Operating current at V_UIN = 30V
0
0
V
16
34
V
1, 2
6
mA
3
I_CL1
Max. output sink current at pins D3...D0, DSTBn
10
mA
I_CL2
Max. output sink current at pins P0...P3, PSTBnBn
10
mA
_amb
Ambient temperature range, operating range
-25
85
°C
1 _{Below VLTGPmin the power supply block may not be able to provide the specified output currents at}
UOUT and U5R.
2 _{Outside of these limits the send current shape and send current amplitude cannot be guaranteed.}
3 _{fc = 16.000 MHz, no load at any pin, transmitter turned off, digital state machine is in idle state}
Table 3: Crystal Frequency
Symbol
f_c
Parameter
Crystal frequency
Nom.
Unit Note
5.333/16.000 MHz ⁴
4 _{The IC automatically detects whether the crystal frequency is 5.333MHz or 16.000MHz and controls}
the internal clock circuit accordingly.
1.3. EMC Behavior
The IC has to fulfill the requirements defined in AS-Interface Complete Specification V2.11 [1] and related test
requirements AS-Interface Slave ICs.
In addition to the AS-Interface Complete Specification and in combination with a reference component circuit
the IC has to achieve a communication failure rate less than 10% of the allowed failure rate according to the
"Fast Transient" test method specified in the related AS-Interface association test procedures.
The above specified behavior is correct by design and has to be proven while IC characterization.
1.4. Quality Standards
The quality of the IC will be ensured according to the ZMDI quality standards. ZMDI is a qualified supplier
according to ISO/TS 16949:2002 and ISO 14001:1996.
The following reference documents apply for the development process:
Management Regulation: 0410 Product Development procedure
Process Specification: ZMDI C7D 0.6µm Technology
Functional device parameters are valid for device operating conditions specified in chapter 1.2 at page 8.
Production device tests are performed within the recommended ranges of V_LTGP - V_LTGN, amb = +25°C
(+85°C and -25°C on sample base only) unless otherwise stated.
Data Sheet
July 17, 2012
© 2012 Zentrum Mikroelektronik Dresden AG — Rev. 3.1
All rights reserved. The material contained herein may not be reproduced, adapted, merged, translated, stored, or used without
the prior written consent of the copyright owner. The information furnished in this publication is PRELIMINARY and subject to
changes without notice.
10 of 62