|
SAM9260_14 Datasheet, PDF (765/784 Pages) ATMEL Corporation – AT91SAM ARM-based Embbedded MPU | |||
|
◁ |
Revision
6221I
Comments
Erratum added to rev A as Section 43.1.12 âStatic Memory Controller (SMC)â on page 749
Table 41-1, âSoldering Informationâ on page 737 edited
âactivatedâ changed into âdeactivatedâ for Active mode in Table 40-3 on page 711
Erratum added to rev A as Section 44.2.2.3 âUser Reset trigger is enabled by defaultâ on page 752
Line added to ⢠âDebug Unit (DBGU)â on page 2, and to 27.1 âDescriptionâ on page 297
Note edited after Table 9-1, âSAM9260 Peripheral Identifiersâ on page 23
âManchester Encoding/Decodingâ removed from Section ⢠âFour Universal Synchronous/Asynchronous
Receiver Transmitters (USART)â on page 2
Rev B Erratum 44.3.7.3 âSPI: Software Reset Needs to be Written Twiceâ edited, then moved to Rev A
Section 43.1.10.4 on page 748
Section 6.6 âShutdown Logic Pinsâ on page 13 edited
2 FOUT values changed in Table 40-15 on page 717
Erratum added to rev A as Section 43.1.13 âShutdown Controller (SHDWC)â on page 749, and to rev B as
Section 43.2.10 âShutdown Controller (SHDWC)â on page 759
Erratum added to rev A as Section 43.1.7.1 âRSTC: Reset during SDRAM Accessesâ on page 745, and to rev
B as Section 43.2.7.1 âRSTC: Reset during SDRAM Accessesâ on page 757
Vin row added to Table 40-13 on page 716
Text of Section 43.1.6.2 âMCI: SDIO Interrupt Does Not Work With Slots Other Than Aâ on page 744 slightly
edited
See issue 6030
Section 40.4 âCore Power Supply POR Characteristicsâ on page 711 added
Various edits to Section 13. âSAM9260 Boot Programâ:
- 2 rows added to Table 13-8 on page 86
- Bullet 9 removed from Section 13.3 âDevice Initializationâ on page 77
- 1 row removed from Table 13-11 on page 88
- Second line and table removed from Section 13.5 âNAND Flash Bootâ on page 83
- Timeout removed from Figure 13-1 on page 76
- SAM-BA Boot replaced by SAM-BA Monitor
- Section 13.8 âROM Code Change Logâ on page 88 added
See issue 5801
âselectable by softwareâ removed from Table 40-2 on page 709
VDDPLL value range for tst changed in Table 40-11 on page 715
- Features shortened and reorganized, from new structure in Datasheet AT91SAM9G45
- Section 8.5 âBackup Sectionâ on page 22 added
- Information from sections 7.1 to 7.4 moved to sections 11.2, 19.2, 24.2 and 12.2, with âEmbedded
Characteristicsâ header
- Information from sections 9.2 to 9.4, 9.6 to 9.8 and 9.10 to 9.11to 7.4 moved to sections 13.2, 18.2, 25.2,
17.2, 16.2, 15.2, 27.2 and 28.2, with âEmbedded Characteristicsâ header
- Information from sections 10.4.1 to 10.4.11 moved to sections 30.2 to 35.2, 38.2, 37.2, 36.2, 39.2 and 4.2,
with âEmbedded Characteristicsâ header
- Sections 41.5.3 and 41.5.4 moved after Section 40.6.4 âCrystal Characteristicsâ on page 716
Change
Request
Ref
5642
5744
5801
5825
5846
5854
5933
5955
6030
6049
6069
6083
6162
6169
6185
6188
6314
6343
6402
6425
RFO
SAM9260 [DATASHEET]
6221KâATARMâ15-Oct-12
765
|
▷ |