SAM9260_14 Datasheet, PDF (63/784 Pages) ATMEL Corporation – AT91SAM ARM-based Embbedded MPU

duration of an assertion between 60 µs and 2 seconds. Note that ERSTL at 0 defines a two-cycle duration for the
NRST pulse.
This feature allows the Reset Controller to shape the NRST pin level, and thus to guarantee that the NRST line is
driven low for a time compliant with potential external devices connected on the system reset.
As the field is within RSTC_MR, which is backed-up, this field can be used to shape the system power-up reset for
devices requiring a longer startup time than the Slow Clock Oscillator.
12.4.3 BMS Sampling
The product matrix manages a boot memory that depends on the level on the BMS pin at reset. The BMS signal is
sampled three slow clock cycles after the Core Power-On-Reset output rising edge.
Figure 12-3. BMS Sampling
SLCK
Core Supply
POR output
BMS Signal
proc_nreset
XXX
BMS sampling delay
= 3 cycles
H or L
12.4.4 Reset States
The Reset State Manager handles the different reset sources and generates the internal reset signals. It reports
the reset status in the field RSTTYP of the Status Register (RSTC_SR). The update of the field RSTTYP is per-
formed when the processor reset is released.
12.4.4.1 General Reset
A general reset occurs when VDDBU and VDDCORE are powered on. The backup supply POR cell output rises
and is filtered with a Startup Counter, which operates at Slow Clock. The purpose of this counter is to make sure
the Slow Clock oscillator is stable before starting up the device. The length of startup time is hardcoded to comply
with the Slow Clock Oscillator startup time.
After this time, the processor clock is released at Slow Clock and all the other signals remain valid for 3 cycles for
proper processor and logic reset. Then, all the reset signals are released and the field RSTTYP in RSTC_SR
reports a General Reset. As the RSTC_MR is reset, the NRST line rises 2 cycles after the backup_nreset, as
ERSTL defaults at value 0x0.
When VDDBU is detected low by the Backup Supply POR Cell, all resets signals are immediately asserted, even if
the Main Supply POR Cell does not report a Main Supply shutdown.
VDDBU only activates the backup_nreset signal.
The backup_nreset must be released so that any other reset can be generated by VDDCORE (Main Supply POR
output).
Figure 12-4 shows how the General Reset affects the reset signals.
SAM9260 [DATASHEET] 63
6221K–ATARM–15-Oct-12