SAM9260_14 Datasheet, PDF (190/784 Pages) ATMEL Corporation – AT91SAM ARM-based Embbedded MPU

• BAT: Byte Access Type
This field is used only if DBW defines a 16- or 32-bit data bus.
• 1: Byte write access type:
– Write operation is controlled using NCS, NWR0, NWR1, NWR2, NWR3.
– Read operation is controlled using NCS and NRD.
• 0: Byte select access type:
– Write operation is controlled using NCS, NWE, NBS0, NBS1, NBS2 and NBS3
– Read operation is controlled using NCS, NRD, NBS0, NBS1, NBS2 and NBS3
• DBW: Data Bus Width
DBW
0
0
0
1
1
0
1
1
Data Bus Width
8-bit bus
16-bit bus
32-bit bus
Reserved
• TDF_CYCLES: Data Float Time
This field gives the integer number of clock cycles required by the external device to release the data after the rising edge
of the read controlling signal. The SMC always provide one full cycle of bus turnaround after the TDF_CYCLES period. The
external bus cannot be used by another chip select during TDF_CYCLES + 1 cycles. From 0 up to 15 TDF_CYCLES can
be set.
• TDF_MODE: TDF Optimization
1: TDF optimization is enabled.
– The number of TDF wait states is optimized using the setup period of the next read/write access.
0: TDF optimization is disabled.
– The number of TDF wait states is inserted before the next access begins.
• PMEN: Page Mode Enabled
1: Asynchronous burst read in page mode is applied on the corresponding chip select.
0: Standard read is applied.
• PS: Page Size
If page mode is enabled, this field indicates the size of the page in bytes.
PS
0
0
0
1
1
0
1
1
Page Size
4-byte page
8-byte page
16-byte page
32-byte page
SAM9260 [DATASHEET]
6221K–ATARM–15-Oct-12
190