AK7746 Datasheet, PDF (44/62 Pages) Asahi Kasei Microsystems – Audio DSP with 5-channel 24-bit ADC and Input Mux

[ASAHI KASEI]
[AK7746]
b) Program RAM writes (during reset phase)
Program RAM write operations are performed during the reset phase using 7-bytes of data. When all data have been transferred, the
RDY terminal is set to "L". Upon completion of writing into the PRAM, RDY returns “H” to allow the next data bit input. When
writing to sequential addresses, input the data without a command code or address. To write discontinuous data, shift the RQ terminal
from "H" to "L" again and then input the command code, address and data in that order.
Data transfer procedure
c Command code C0h ( 1 1 0 0 0 0 0 0)
d Address upper
( 0 0 0 0 0 0 A9 A8)
e Address lower
(A7 . . . . . . . A0)
f Data
(D31 . . . . . . D24)
g Data
(D23 . . . . . . D16)
h Data
(D15 . . . . . . D8)
i Data
(D7 . . . . . . D0)
S_RESET
RQ
SCLK
SI
RDY
SO
11000000
000000A9A8 ^{A7 ****A1A0}
D31***** D0 D31***** D0
Fig.8-16 Input of continuous address data into PRAM
S_RESET
RQ
SCLK
SI
RDY
SO
11000000 000000A9A8 A7**A1A0 D31***D0
11000000 000000A9A8 A7**A1A0
Fig.8-17 Input of discontinuous address data into PRAM
[MS0369-E00]
- 44 -
2004/12