DAC8562SDSCT Datasheet, PDF (41/58 Pages) Texas Instruments – DUAL 16-/14-/12-BIT, ULTRALOW-GLITCH, LOW-POWER, BUFFERED, VOLTAGE-OUTPUT DAC WITH 2.5-V, 4-PPM/°C INTERNAL REFERENCE IN SMALL 3-MM × 3-MM SON

www.ti.com
DAC8562, DAC8563
DAC8162, DAC8163
DAC7562, DAC7563
SLAS719D – AUGUST 2010 – REVISED AUGUST 2012
PLC ANALOG OUTPUT MODULE USING THE DAC8562
The DAC8562 can be mated with one of TI's 0- to 20-mA voltage-to-current transmitters to create a low-cost,
programmable current source for use in PLC applications. One specific example includes combining the
DAC8562 with the XTR111 to create a voltage-to-current solution. The DAC output voltage generates a current,
I_SET, which is determined by the value of the external resistor, R_SET. This current is internally amplified by 10 and
output at the IS node. A p-channel MOSFET Q1 can be added in an application where a wide compliance
voltage is required, for example, when using a high impedance load. The optional PNP transistor, Q2, along with
the R4 resistor provides external current limiting in a case where the external FET is forced to low impedance.
Additionally, resistors R2 and R3 can be used to scale the 3-V internal regulator to a desired voltage to power
the DAC. Figure 97 shows a working 0- to 20-mA solution using one DAC8562 channel and a ±10-V voltage
output using the other DAC8562 channel. For more information on the ±10-V voltage output circuit see the UP
TO ±15-V BIPOLAR OUTPUT USING THE DAC8562 application.
24 V
C1
470 nF
5.5 V
REGF
R2
2.5 kΩ
VSP
IS
Q2
A_VDD
DAC8562
V_OUTA
V_OUTB
R1
2.5 kΩ
0 to 5 V
0 to 5 V
REGS _XTR111
R3
VG
3 kΩ
VIN
SET
R_SET
2.5 kΩ
V_REFOUT
GND
R6
10 kΩ
R7
40 kΩ
18 V
+
OPA140
–
R8
10 kΩ
–18 V
R9
40 kΩ
R4
15 Ω
Q1
R5
15 Ω
C2
10 nF
I_OUT
0- to 20-mA Output
V_OUT
±10-V Output
Figure 97. 0- to 20-mA and ±10-V Outputs Using DAC8562
Copyright © 2010–2012, Texas Instruments Incorporated
Submit Documentation Feedback
41
Product Folder Links: DAC8562 DAC8563 DAC8162 DAC8163 DAC7562 DAC7563