CC3200MOD_15 Datasheet, PDF (27/66 Pages) Texas Instruments – CC3200MOD SimpleLink™ Wi-Fi® and Internet-of-Things Module Solution, a Single-Chip Wireless MCU

www.ti.com
CC3200MOD
SWRS166 – DECEMBER 2014
4.9 Current Consumption
T_A = +25°C, V_BAT = 3.6 V
PARAMETER
TEST CONDITIONS^{(1) (2)}
MIN TYP MAX UNIT
TX power level = 0
278
1 DSSS
TX power level = 4
194
TX
MCU ACTIVE
NWP ACTIVE
TX power level = 0
254
6 OFDM
TX power level = 4
185
TX power level = 0
229
mA
54 OFDM
TX power level = 4
166
RX
NWP idle connected⁽³⁾
1 DSSS
54 OFDM
59
59
15.3
TX power level = 0
275
1 DSSS
TX power level = 4
191
MCU SLEEP
TX
NWP ACTIVE
TX power level = 0
251
6 OFDM
TX power level = 4
182
TX power level = 0
226
mA
54 OFDM
TX power level = 4
163
RX
NWP idle connected⁽³⁾
1 DSSS
54 OFDM
56
56
12.2
TX power level = 0
272
1 DSSS
TX power level = 4
188
TX
NWP active
MCU LPDS
TX power level = 0
248
6 OFDM
TX power level = 4
179
TX power level = 0
223
54 OFDM
mA
TX power level = 4
160
RX
NWP LPDS⁽⁴⁾
NWP idle connected⁽³⁾
1 DSSS
54 OFDM
53
53
0.275
0.875
MCU hibernate
NWP hibernate
7
µA
Peak calibration current ⁽⁵⁾
V_BAT = 3.3 V
V_BAT = 2.3 V
450
mA
620
(1) TX power level = 0 implies maximum power (see Figure 4-3 through Figure 4-5). TX power level = 4 implies output power backed off
approximately 4 dB.
(2) The CC3200 system is a constant power-source system. The active current numbers scale based on the V_BAT voltage supplied.
(3) DTIM = 1
(4) The LPDS number reported is with retention of 64KB MCU SRAM. The CC3200 device can be configured to retain 0KB, 64KB, 128KB,
192KB or 256KB SRAM in LPDS. Each 64KB retained increases LPDS current by 4 µA.
(5) The complete calibration can take up to 17 mJ of energy from the battery over a time of 24 ms . Calibration is performed sparingly,
typically when coming out of Hibernate and only if temperature has changed by more than 20°C or the time elapsed from prior
calibration is greater than 24 hours.
Copyright © 2014, Texas Instruments Incorporated
Submit Documentation Feedback
Specifications
27