CC3200MOD_15 Datasheet, PDF (25/66 Pages) Texas Instruments – CC3200MOD SimpleLink™ Wi-Fi® and Internet-of-Things Module Solution, a Single-Chip Wireless MCU

www.ti.com
CC3200MOD
SWRS166 – DECEMBER 2014
4.6 Electrical Characteristics (3.3 V, 25°C)
GPIO Pins Except 29, 30, 45, 50, 52, and 53 (25°C)⁽¹⁾
PARAMETER
TEST
MIN
CONDITIONS
NOM
MAX
UNIT
C_IN
Pin capacitance
V_IH
High-level input voltage
V_IL
Low-level input voltage
I_IH
High-level input current
I_IL
Low-level input current
V_OH
High-level output voltage (VDD =
3.0 V)
4
pF
0.65 × VDD
VDD + 0.5 V
V
–0.5
0.35 × VDD
V
5
nA
5
nA
2.4
V
V_OL
Low-level output voltage (VDD =
3.0 V)
0.4
V
I_OH
High-level
2-mA Drive
2
mA
source current,
VOH = 2.4
4-mA Drive
4
mA
6-mA Drive
6
mA
I_OL
Low-level sink 2-mA Drive
2
mA
current,
VOH = 0.4
4-mA Drive
4
mA
6-mA Drive
6
mA
(1) TI recommends using the lowest possible drive strength that is adequate for the applications. This recommendation minimizes the risk of
interference to the WLAN radio and mitigates any potential degradation of RF sensitivity and performance. The default drive strength
setting is 6 mA.
GPIO Pins 29, 30, 45, 50, 52, and 53 (25°C)⁽¹⁾
PARAMETER
TEST
CONDITIONS
MIN
NOM
MAX
UNIT
C_IN
Pin capacitance
V_IH
High-level input voltage
V_IL
Low-level input voltage
I_IH
High-level input current
I_IL
Low-level input current
V_OH
High-level output voltage
(VDD= 3.0 V)
0.65 × VDD
–0.5
2.4
7
pF
VDD + 0.5V
V
0.35 × VDD
V
50
nA
50
nA
V
V_OL
Low-level output voltage
(VDD= 3.0 V)
0.4
V
I_OH
High-level
2-mA Drive
1.5
mA
source current,
V_OH = 2.4
4-mA Drive
2.5
mA
6-mA Drive
3.5
mA
I_OL
Low-level sink 2-mA Drive
current, V_OH =
0.4
4-mA Drive
6-mA Drive
V_IL
nRESET ⁽²⁾
1.5
mA
2.5
mA
3.5
mA
0.6
V
(1) TI recommends using the lowest possible drive strength that is adequate for the applications. This recommendation minimizes the risk of
interference to the WLAN radio and mitigates any potential degradation of RF sensitivity and performance. The default drive strength
setting is 6 mA.
(2) The nRESET pin must be held below 0.6 V to ensure the device is reset properly.
Copyright © 2014, Texas Instruments Incorporated
Submit Documentation Feedback
Specifications
25