COM20020I_0609 Datasheet, PDF (67/69 Pages) SMSC Corporation – 5Mbps ARCNET (ANSI 878.1) Controller with 2K x 8 On-Chip RAM

5Mbps ARCNET (ANSI 878.1) Controller with 2K x 8 On-Chip RAM
The EF bit also controls the resolution of the following issues from the COM20020I Rev. B:
A) Network MAP Generation
Tentative ID is used for generating the Network MAP, but it sometimes detects a non-existent node. Every time the
Tentative-ID register is written, the effect of the old Tentative-ID remains active for a while, which results in an incorrect
network map. It can be avoided by a carefully coded software routine, but this requires the programmer to have deep
knowledge of how the COM20020I 3V works. Duplicate-ID is mainly used for generating the Network MAP. This has
the same issue as Tentative-ID.
A minor logic change clears all the remaining effects of the old Tentative-ID and the old Duplicate-ID, when the
COM20020I 3V detects a write operation to Tentative-ID or Node-ID register. With this change, programmers can use
the Tentative-ID or Duplicate-ID for generating the network MAP without any issues. This change is Enabled/Disabled
by the EF bit.
B) Mask Register Reset
The Mask register is reset by a soft reset in the COM20020I 3V Rev. A, but is not reset in Rev. B. The Mask register is
related to the Status and Diagnostic register, so it should be reset by a soft reset. Otherwise, every time the soft reset
happens, the COM20020I 3V Rev. B generates an unnecessary interrupt since the status bits RI and TA are back to
one by the soft reset.
This is resolved by changing the logic to reset the Mask register both by the hard reset and by the soft reset. The soft
reset is activated by the Node-ID register going to 00h or by the RESET bit going to High in the Configuration register.
This solution is Enabled/Disabled by the EF bit.
SMSC COM20020I 3.3V Rev.E
Page 67
DATASHEET
Revision 09-11-06