H8S2148 Datasheet, PDF (878/1177 Pages) Renesas Technology Corp – Renesas 16-Bit Single-Chip Microcomputer H8S Family/H8S/2100 Series

Section 26 Electrical Characteristics
Notes: 1. Set the times according to the program/erase algorithms.
2. Programming time per 128 bytes (Shows the total period for which the P-bit in FLMCR1
is set. It does not include the programming verification time.)
3. Block erase time (Shows the total period for which the E-bit in FLMCR1 is set. It does
not include the erase verification time.)
4. Maximum programming time (tP (max))
tP(max) = (Wait time after P-bit setting (z1) + (z3)) × 6 + Wait time after P-bit setting (z2)
× ((N) – 6)
5. Maximum programming count (N) should be set according to the actual set value of (z1,
z2, z3) to allow programming within the maximum programming time (tP(max)). The
wait time after P-bit setting (z1, z2, z3) must be changed with the value of the number
of writing times (n) as follows.
The number of times for writing n
1≤n≤6
z1 = 30 µs, z3 = 10 µs
7 ≤ n ≤ 1000
z2 = 200 µs
6. Maximum erase time (tE (max))
tE(max) = Waiting time after E-bit setting (z) × Maximum erase count (N)
7. Maximum erase count (N) should be set according to the actual setting (z) to allow
erase within the maximum erase time (tE(max)).
8. Minimum number of times for which all characteristics are guaranteed after rewriting
(Guarantee range is 1 to minimum value).
9. Reference value for 25°C (as a guideline, rewriting should normally function up to this
value).
10. Data retention characteristic when rewriting is performed within the specification range,
including the minimum value.
Rev. 4.00 Sep 27, 2006 page 834 of 1130
REJ09B0327-0400