H8S2148 Datasheet, PDF (273/1177 Pages) Renesas Technology Corp – Renesas 16-Bit Single-Chip Microcomputer H8S Family/H8S/2100 Series

Section 8 I/O Ports
• Modes 2 and 3 (EXPE = 0)
The corresponding port 2 pins are output ports or PWM outputs when P2DDR bits are set to 1,
and input ports when cleared to 0.
P27 can be used as an on-chip supporting module output pin regardless of the P27DDR setting.
Port 2 Data Register (P2DR)
Bit
Initial value
R/W
7
P27DR
0
R/W
6
P26DR
0
R/W
5
P25DR
0
R/W
4
P24DR
0
R/W
3
P23DR
0
R/W
2
P22DR
0
R/W
1
P21DR
0
R/W
0
P20DR
0
R/W
P2DR is an 8-bit readable/writable register that stores output data for the port 2 pins (P27 to P20).
If a port 2 read is performed while P2DDR bits are set to 1, the P2DR values are read directly,
regardless of the actual pin states. If a port 2 read is performed while P2DDR bits are cleared to 0,
the pin states are read.
P2DR is initialized to H'00 by a reset and in hardware standby mode. It retains its prior state in
software standby mode.
Port 2 MOS Pull-Up Control Register (P2PCR)
Bit
Initial value
R/W
7
6
5
4
3
2
1
0
P27PCR P26PCR P25PCR P24PCR P23PCR P22PCR P21PCR P20PCR
0
0
0
0
0
0
0
0
R/W
R/W
R/W
R/W
R/W
R/W
R/W
R/W
P2PCR is an 8-bit readable/writable register that controls the port 2 built-in MOS input pull-ups
on a bit-by-bit basis.
In modes 2 and 3, the MOS input pull-up is turned on when a P2PCR bit is set to 1 while the
corresponding P2DDR bit is cleared to 0 (input port setting).
P2PCR is initialized to H'00 by a reset and in hardware standby mode. It retains its prior state in
software standby mode.
Rev. 4.00 Sep 27, 2006 page 229 of 1130
REJ09B0327-0400