RZT1_15 Datasheet, PDF (8/52 Pages) Renesas Technology Corp – 450 MHz/600MHz, MCU with ARM Cortex®-R4F

Under development ^{Preliminary document}
Specifications in this document are tentative and subject to change.
RZ/T1 Group
1. Overview
Table 1.1
Outline of Specifications (7 / 7)
Classification
Safety
Module/Function
Description
Register write protection Protects important registers from being overwritten for in case a program runs out of
function
control.
CRC calculator (CRC)
 CRC code generation for arbitrary amounts of data in 8-, 16-, or 32-bit units
 Select any of four generating polynomials:
X³² + X²⁶ + X²³ + X²² + X¹⁶ + X¹² + X¹¹ + X¹⁰ + X⁸ + X⁷ + X⁵ + X⁴ + X² + X + 1 (32-
Ethernet),
X¹⁶ + X¹² + X⁵ + 1 (16-CCITT),
X⁸ + X⁴ + X³ + X² + 1 (8-SAEJ1850),
X⁸ + X⁵ + X³ + X² + X + 1 (8-0x2F)
Input clock oscillation
stop function
Input clock oscillation stop detection: Available
Clock monitor circuit
(CLMA)
Monitors the abnormal output clock frequency from the PLL circuit or low-speed on-chip
oscillator.
Data operation circuit
(DOC)
Error control module
(ECM)
Security
Secure boot mode*⁴
Encoder interfaces*⁵
Power supply voltage
Operating temperature
Package
The function to compare, add, or subtract 16-bit data
 Generates an interrupt, internal reset, or error output for the error signal input from each
module.
 Time-out function
 The error output is duplicated in the master and the checker.
As an option, a boot mode with encryption as a security function is available.
EnDat 2.2 and BiSS-compliant interfaces
VDD = PLLVDD0 = PLLVDD1 = DVDD_USB = 1.14 to 1.26 V
VCCQ33 = AVCC0 = AVCC1 = VREFH0 = VREFH1 = VDD33_USB = 3.0 to 3.6 V
Tj = -40 to +125°C
320-pin FBGA: 17 × 17 mm, 0.8-mm pitch PRBG0320GA-A
176-pin HLQFP: 20 × 20 mm, 0.4-mm pitch PLQP0176LD-A
Debugging interface
 CoreSight architecture designed by ARM
 Debugging function by the JTAG/SWD interface, and trace function by the trace port/
SWV interface
Note 1. One unit for 176-pin devices (only unit 0 is provided)
Note 2. EtherCAT is a registered trademark of Beckhoff Automation GmbH, Germany.This controller is only included in products
incorporating an R-IN engine.
Note 3. Not included in 176-pin devices.
Note 4. See Figure 1.3, List of Products, for the products that have the secure boot mode. Details of these optional functions will only be
given after completion of a binding non-disclosure agreement. For details, contact our sales representative.
Note 5. For details, contact our sales representative.
R01DS0228EJ0070 Rev.0.70
Dec 25, 2014
Page 8 of 52