AN91267 Datasheet, PDF (34/62 Pages) Ramtron International Corporation – Getting Started with PSoC

Getting Started with PSoC® 4 BLE
Part 4: Test Your Design
This section describes how to test your BLE design using the CySmart mobile apps and PC tool. The setup for testing your
design using the BLE Pioneer Kit is shown in Figure 15.
1. Turn on Bluetooth on your iOS or Android device.
2. Launch the CySmart app.
3. Press the reset switch on the BLE Pioneer Kit to start BLE advertisements from your design.
4. Pull down the CySmart app home screen to start scanning for BLE Peripherals, your device will now appear in the
CySmart app home screen. Select your device to establish a BLE connection.
5. Select the “Find Me” Profile from the carousel view.
6. Select one of the Alert Level values on the Find Me Profile screen and observe the state of the LED on your device
change per your selection.
A step-by-step configuration screenshot of the CySmart mobile app is shown in Figure 46 and Figure 47.
Figure 46. Testing with CySmart iOS App
Select your
device
Select Find Me
Profile
Select Alert
Level
www.cypress.com
Document No. 001-91267 Rev. *D
34