AN91267 Datasheet, PDF (23/62 Pages) Ramtron International Corporation – Getting Started with PSoC

Figure 33. Disconnection LED Configuration
Getting Started with PSoC® 4 BLE
11. After completing the schematic configuration, your design should look similar to Figure 34.
Figure 34. Schematic Configuration
Note The blue dotted lines, the LED symbols, and resistor symbols shown in Figure 34 are off-chip PSoC Creator
Components that are present only for descriptive purposes and are not required for the functioning of your design. You can
add off-chip Components to your design by dragging and dropping the required off-chip Components on to your project
schematic page from PSoC Creator’s off-chip Component Catalog.
www.cypress.com
Document No. 001-91267 Rev. *D
23