AN91267 Datasheet, PDF (22/62 Pages) Ramtron International Corporation – Getting Started with PSoC

Figure 31. Renaming a Pin Component
Getting Started with PSoC® 4 BLE
10. Add two more Digital Output Pin Components named Advertising_LED and Disconnect_LED to your design (see Figure
30 and Figure 31) with HW Connection deselected and Initial drive state set to “High(1),” as Figure 32 and Figure 33
show. These pins will be used to drive the BLE advertising and disconnection state indicator LEDs. The LEDs on the BLE
Pioneer Kit are active LOW; that is, the high pin-drive state turns off the LEDs and the low pin-drive state turns them on.
Figure 32. Advertising LED Configuration
www.cypress.com
Document No. 001-91267 Rev. *D
22