AN91267 Datasheet, PDF (24/62 Pages) Ramtron International Corporation – Getting Started with PSoC

Getting Started with PSoC® 4 BLE
12. Open the file BLE_FindMe.cydwr (Design-Wide Resources) file from Workspace Explorer and click the Pins tab. You
can use this tab to select the device pins for the outputs (Advertising_LED, Disconnect_LED, and Alert_LED). Figure 35
shows the pin configuration to connect the Advertising_LED, Disconnect LED, and Alert_LED pins to the green, red, and
blue LEDs on the BLE Pioneer Kit respectively.
Figure 35. Pin Selection
If you are using your own board or a development kit with no LEDs, select the appropriate pins. You can connect external
LEDs to the selected pins, as Figure 17 shows.
13. Similarly, in the Clocks tab under the BLE_FindMe.cydwr file, double click on IMO to configure the internal main oscillator
(IMO) to 12 MHz, as Figure 36 shows. Click OK.
Figure 36. Clock Configuration
www.cypress.com
Document No. 001-91267 Rev. *D
24