AN91267 Datasheet, PDF (33/62 Pages) Ramtron International Corporation – Getting Started with PSoC

Getting Started with PSoC® 4 BLE
1. In the Select Debug Target dialog box, click Port Acquire, and then click Connect, as Figure 43 shows. Click OK to
close the dialog box.
Figure 43. Connecting to a Device
If you are using your own hardware, make sure the Port Setting configuration in the Select Debug Target window for
your programming hardware is configured per your setup.
2. In PSoC Creator, choose Debug > Program to program the device with the project, as Figure 44 shows.
Figure 44. Programming the Device
3. You can view the programming status on the PSoC Creator status bar (lower left corner of the window), as Figure 45
shows,
Figure 45. Programming Status
www.cypress.com
Document No. 001-91267 Rev. *D
33