AN91267 Datasheet, PDF (10/62 Pages) Ramtron International Corporation – Getting Started with PSoC

Getting Started with PSoC® 4 BLE
BLE Component
The BLE Component in PSoC Creator abstracts the BLE protocol complexity into a simple and easy-to-use GUI and a few
APIs. It takes five steps to configure the BLE Component as a standard BLE Peripheral:
Step 1: Select a desired Profile and Profile role for your design. The BLE Component will automatically select the required
GAP and GATT roles for the selected Profile role, as shown in Figure 11.
Figure 11. BLE Profile Configuration
Select Profile
Collection
Pick a Profile
Pick a Profile Role
GAP role is auto selected
Step 2: For the selected Profile role, all the supported GATT Services and their corresponding Characteristics are auto-
generated per the Profile specification. Verify and/or edit the Service and Characteristic values if required. The configurations
in the Profiles tab form the Attribute database for the selected design.
Figure 12. BLE Attribute Database Configuration
GAP Service
GATT Service
Alert Service as per
Find Me Profile Spec
Characteristic Value
Characteristic Descriptor
Find Me Target Profile
Attribute Database
Step 3: Configure the GAP general and advertisement data settings for your design, as shown in Figure 13 and Figure 14.
www.cypress.com
Document No. 001-91267 Rev. *D
10