AN91267 Datasheet, PDF (32/62 Pages) Ramtron International Corporation – Getting Started with PSoC

Getting Started with PSoC® 4 BLE
}
else
{
/* Keep trying to enter either Sleep or Deep-Sleep mode */
}
CyExitCriticalSection(intrStatus);
/* BLE link layer timing interrupt will wake up the system from Sleep
* and Deep-Sleep modes */
}
Part 3: Program the Device
This section shows how to program the PSoC 4 BLE device. If you are using a development kit with a built-in programmer (the
BLE Pioneer Kit, for example), connect the kit board to your computer using the USB cable. For other kits, refer to the kit
guide.
Note The source project for this design is in PSoC Creator 3.2 or later under File > Example Project > select Keyword as
Find Me > BLE_FindMe.
If you are developing on your own hardware, you need a hardware debugger, for example, a Cypress CY8CKIT–002
MiniProg3. In PSoC Creator, choose Debug > Select Debug Target, as Figure 42 shows.
Figure 42. Selecting Debug Target
www.cypress.com
Document No. 001-91267 Rev. *D
32