AN91267 Datasheet, PDF (15/62 Pages) Ramtron International Corporation – Getting Started with PSoC

Getting Started with PSoC® 4 BLE
Part 1: Configure the Design
This section takes you on a step-by-step guided tour of the design process. It starts with creating an empty project and guides
you through schematic design entry. You can skip this section if you simply wish to try the example project provided with this
application note without going through the build process.
1. Install PSoC Creator 3.2 or later on your PC.
2. Start PSoC Creator, and from the File menu, choose New > Project, as Figure 18 shows.
Figure 18. Creating a New Project
3. Select the project template “PSoC 4100/4200-BL Design,” and give the project a name such as “BLE_FindMe,” as Figure
19 shows. Choose the Project template as “Empty schematic”. Choose an appropriate location for your new project, and
then click OK.
Figure 19. Naming the New Project
www.cypress.com
Document No. 001-91267 Rev. *D
15