AN91267 Datasheet, PDF (17/62 Pages) Ramtron International Corporation – Getting Started with PSoC

Getting Started with PSoC® 4 BLE
7. Drag one Bluetooth Low Energy (BLE) Component from the Component Catalog onto the schematic, as Figure 22
shows.
Figure 22. Location of the BLE Component
8. Double-click the BLE Component on the schematic to configure it as a “BLE Find Me Target” with the following properties:
 ^{GAP Peripheral role with Find Me Target (GATT server) configuration}
 ^{GAP Device Name set to “Find Me Target” and Appearance set to “Generic Keyring.” This configures the device}
name and type that will appear when another device attempts to discover your device.
 Limited advertisement mode with an advertising timeout of 30 seconds and a fast advertisement interval of 20 to
30 ms. Fast advertising allows quick discovery and connection but consumes more power due to increased RF
advertisement packets.
 Advertisement Packet with Immediate Alert Service enabled and Scan Response Packet with Local Name, Tx Power
Level, and Appearance fields enabled.
 GAP security set to the lowest possible configuration that does not require authentication, encryption, or authorization
for data exchange (Mode 1, No Security)
Figure 23 to Figure 29 show the BLE Component screenshots for this configuration.
Note You do not need to change the default configuration of the BLE Component in the Profiles tab for this design.
www.cypress.com
Document No. 001-91267 Rev. *D
17