HYB18T1G400BF_07 Datasheet, PDF (45/74 Pages) Qimonda AG – 1-Gbit Double-Data-Rate-Two SDRAM

Internet Data Sheet
HY[B/I]18T1G[40/80/16]0B[C/F](L/V)
1-Gbit Double-Data-Rate-Two SDRAM
7
Timing Characteristics
This chapter contains speed grade definition, AC timing parameter and ODT tables.
7.1
Speed Grade Definitions
All Speed grades faster than DDR2-400B comply with DDR2-400B timing specifications (t_CK = 5ns with t_RAS = 40ns).
Speed Grade
TABLE 49
Speed Grade Definition Speed Bins for DDR2–800
DDR2–800D
DDR2–800E
Unit Note
QAG Sort Name
–2.5F
–2.5
CAS-RCD-RP latencies
5–5–5
6–6–6
t_CK
Parameter
Symbol
Min. Max.
Min. Max.
—
Clock Frequency
@ CL = 3
t_CK
5
8
5
8
ns
1)2)3)4)
@ CL = 4
t_CK
3.75 8
3.75 8
ns
1)2)3)4)
@ CL = 5
t_CK
2.5
8
3
8
ns
1)2)3)4)
@ CL = 6
t_CK
2.5
8
2.5
8
ns
1)2)3)4)
Row Active Time
t_RAS
45
70000
45
70000
ns
1)2)3)4)5)
Row Cycle Time
t_RC
57.5 —
60
—
ns
1)2)3)4)
RAS-CAS-Delay
t_RCD
12.5 —
15
—
ns
1)2)3)4)
Row Precharge Time
t_RP
12.5 —
15
—
ns
1)2)3)4)
1) Timings are guaranteed with CK/CK differential Slew Rate of 2.0 V/ns. For DQS signals timings are guaranteed with a differential Slew
Rate of 2.0 V/ns in differential strobe mode and a Slew Rate of 1 V/ns in single ended mode. Timings are further guaranteed for normal
OCD drive strength (EMRS(1) A1 = 0) under the “Reference Load for Timing Measurements”.
2) The CK/CK input reference level (for timing reference to CK/CK) is the point at which CK and CK cross. The DQS / DQS, RDQS / RDQS,
input reference level is the crosspoint when in differential strobe mode; The input reference level for signals other than CK/CK, DQS / DQS,
RDQS / RDQS is defined .
3) Inputs are not recognized as valid until V_REF stabilizes. During the period before V_REF stabilizes, CKE = 0.2 x V_DDQ is recognized as low.
4) The output timing reference voltage level is V_TT.
5) t_RAS.MAX is calculated from the maximum amount of time a DDR2 device can operate without a refresh command which is equal to 9 x t_REFI.
Rev. 1.3, 2007-07
45
03062006-ZNH8-HURV