English
Language : 

PIC32MX795F512L-80IPT Datasheet, PDF (4/68 Pages) Microchip Technology – PIC32 Flash Programming Specification
PIC32
7. Download the Block of Data to Program.
All methods, with or without the PE, must down-
load the desired programming data into a block
of memory in RAM.
See Section 12.0 “Downloading a Data
Block” for more information.
8. Initiate Flash Write.
After downloading each block of data into RAM,
the programming sequence must be started to
program it into the target device’s Flash
memory.
See Section 13.0 “Initiating a Flash Row
Write” for more information.
9. Repeat Steps 7 and 8 until all data blocks are
downloaded and programmed.
10. Verify the program memory.
After all programming data and Configuration
bits are programmed, the target device memory
should be read back and verified for the
matching content.
See Section 14.0 “Verify Device Memory” for
more information.
11. Exit the Programming mode.
The newly programmed data is not effective until
either power is removed and reapplied to the
target device or an exit programming sequence
is performed.
See Section 15.0 “Exiting Programming
Mode” for more information.
DS61145L-page 4
 2007-2013 Microchip Technology Inc.