PIC24HJ32GP302_11 Datasheet, PDF (313/368 Pages) Microchip Technology – High-Performance, 16-bit Microcontrollers

PIC24HJ32GP302/304, PIC24HJ64GPX02/X04 AND PIC24HJ128GPX02/X04
TABLE 28-35: SPIx SLAVE MODE (FULL-DUPLEX, CKE = 0, CKP = 0, SMP = 0) TIMING
REQUIREMENTS
AC CHARACTERISTICS
Standard Operating Conditions: 3.0V to 3.6V
(unless otherwise stated)
Operating temperature -40°C ≤TA ≤+85°C for Industrial
-40°C ≤TA ≤+125°C for Extended
Param
No.
Symbol
Characteristic⁽¹⁾
Min
Typ⁽²⁾ Max Units
Conditions
SP70 TscP
Maximum SCK Input Frequency
—
—
11 MHz See Note 3
SP72 TscF
SCKx Input Fall Time
—
—
—
ns See parameter DO32
and Note 4
SP73 TscR
SCKx Input Rise Time
—
—
—
ns See parameter DO31
and Note 4
SP30 TdoF
SDOx Data Output Fall Time
—
—
—
ns See parameter DO32
and Note 4
SP31 TdoR
SDOx Data Output Rise Time
SP35 TscH2doV, SDOx Data Output Valid after
TscL2doV SCKx Edge
—
—
—
ns See parameter DO31
and Note 4
—
6
20 ns
—
SP36 TdoV2scH, SDOx Data Output Setup to
30
—
—
ns
—
TdoV2scL First SCKx Edge
SP40 TdiV2scH, Setup Time of SDIx Data Input
30
—
—
ns
—
TdiV2scL to SCKx Edge
SP41 TscH2diL, Hold Time of SDIx Data Input
30
—
—
ns
—
TscL2diL to SCKx Edge
SP50 TssL2scH, SSx ↓to SCKx ↑ or SCKx Input
120
—
—
ns
—
TssL2scL
SP51 TssH2doZ SSx ↑ to SDOx Output
High-Impedance⁽⁴⁾
10
—
50
ns
—
SP52 TscH2ssH SSx after SCKx Edge
TscL2ssH
1.5 TCY + 40 —
—
ns ^{See Note 4}
Note 1: These parameters are characterized, but are not tested in manufacturing.
2: Data in “Typ” column is at 3.3V, 25°C unless otherwise stated.
3: The minimum clock period for SCKx is 91 ns. Therefore, the SCK clock generated by the Master must not
violate this specificiation.
4: Assumes 50 pF load on all SPIx pins.
© 2011 Microchip Technology Inc.
DS70293E-page 313