PIC16F870_13 Datasheet, PDF (134/172 Pages) Microchip Technology – 28/40-Pin, 8-Bit CMOS FLASH Microcontrollers

PIC16F870/871
TABLE 14-9: PIC16F870/871 (INDUSTRIAL)
PIC16LF870/871 (INDUSTRIAL)
Param
No.
Sym
Characteristic
Min
Typ†
Max
Units
Conditions
A01 NR Resolution
—
—
10-bits
bit VREF = VDD = 5.12V,
VSS  VAIN  VREF
A03 EIL Integral linearity error
—
—
<±1
LSb ^{VREF = VDD = 5.12V,}
VSS  VAIN  VREF
A04 EDL Differential linearity error
—
—
<±1
LSb ^{VREF = VDD = 5.12V,}
VSS  VAIN  VREF
A06 EOFF Offset error
—
—
<±1
LSb ^{VREF = VDD = 5.12V,}
VSS  VAIN  VREF
A07 EGN Gain error
—
—
<±1
LSb ^{VREF = VDD = 5.12V,}
VSS  VAIN  VREF
A10
— _Monotonicity⁽³⁾
—
guaranteed
—
— VSS  VAIN  VREF
A20 VREF Reference voltage (VREF+ – VREF-)
2.0V
—
VDD + 0.3 V
A21 VREF+ Reference voltage High
VDD – 2.5V
VDD + 0.3V V Must meet spec. A20
A22 VREF- Reference voltage Low
VSS – 0.3V
VREF+ – 2.0V V Must meet spec. A20
A25 VAIN Analog input voltage
VSS – 0.3
—
VREF + 0.3 V
A30 ZAIN Recommended impedance of
analog voltage source
—
—
10.0
k
A40 IAD A/D conversion
Standard(F)
—
220
—
A Average current consumption
current (VDD)
Extended(LF)
—
90
—
A ^{when A/D is on (Note 1).}
A50 IREF VREF input current (Note 2)
10
—
1000
A During VAIN acquisition.
Based on differential of VHOLD
to VAIN to charge CHOLD, see
Section 10.1.
—
—
10
A During A/D Conversion cycle
* These parameters are characterized but not tested.
† Data in "Typ" column is at 5V, 25°C unless otherwise stated. These parameters are for design guidance only and are not
tested.
Note 1: When A/D is off, it will not consume any current other than minor leakage current. The power-down current spec includes
any such leakage from the A/D module.
2: VREF current is from RA3 pin or VDD pin, whichever is selected as reference input.
3: The A/D conversion result never decreases with an increase in the input voltage, and has no missing codes.
DS30569C-page 134
 2000-2013 Microchip Technology Inc.