PIC18F2221_1 Datasheet, PDF (108/402 Pages) Microchip Technology – Enhanced Flash Microcontrollers with 10-Bit A/D and nanoWatt Technology

PIC18F2221/2321/4221/4321 FAMILY
10.5 RCON Register
The RCON register contains flag bits which are used to
determine the cause of the last Reset or wake-up from
Idle or Sleep modes. RCON also contains the IPEN bit
which enables interrupt priorities.
The operation of the SBOREN bit and the Reset flag
bits is discussed in more detail in Section 5.1 “RCON
Register”.
REGISTER 10-10: RCON: RESET CONTROL REGISTER
R/W-0 R/W-1⁽¹⁾
U-0
R/W-1
R-1
IPEN SBOREN
—
RI
TO
bit 7
R-1
R/W-0⁽²⁾ R/W-0
PD
POR
BOR
bit 0
bit 7 IPEN: Interrupt Priority Enable bit
1 = Enable priority levels on interrupts
0 = Disable priority levels on interrupts (PIC16XXX Compatibility mode)
bit 6 SBOREN: Software BOR Enable bit⁽¹⁾
For details of bit operation, see Register 5-1.
bit 5 Unimplemented: Read as ‘0’
bit 4 RI: RESET Instruction Flag bit
For details of bit operation, see Register 5-1.
bit 3 TO: Watchdog Time-out Flag bit
For details of bit operation, see Register 5-1.
bit 2 PD: Power-down Detection Flag bit
For details of bit operation, see Register 5-1.
bit 1 POR: Power-on Reset Status bit⁽²⁾
For details of bit operation, see Register 5-1.
bit 0 BOR: Brown-out Reset Status bit
For details of bit operation, see Register 5-1.
Note 1: If SBOREN is enabled, its Reset state is ‘1’; otherwise, it is ‘0’.
2: Actual Reset values are determined by device configuration and the nature of the
device Reset. See Register 5-1 for additional information.
Legend:
R = Readable bit
-n = Value at POR
W = Writable bit
‘1’ = Bit is set
U = Unimplemented bit, read as ‘0’
‘0’ = Bit is cleared
x = Bit is unknown
DS39689F-page 108
© 2009 Microchip Technology Inc.