71M6533 Datasheet, PDF (1/132 Pages) Teridian Semiconductor Corporation – Energy Meter IC

19-5373; Rev 2; 2/12
71M6533/G/H and 71M6534/H
Energy Meter ICs
DATA SHEET
GENERAL DESCRIPTION
FEATURES
The Teridian™ 71M6533 and 71M6534 are third-generation
polyphase metering systems-on-chips (SoCs) with a 10MHz 8051-
compatible MPU core, low-power RTC, flash, and LCD driver. The
Single Converter Technology® with a 22-bit delta-sigma ADC, seven
analog inputs, digital temperature compensation, precision voltage
reference, and a 32-bit computation engine (CE) supports a wide
range of metering applications with very few external components.
• Wh Accuracy < 0.1% Over 2000:1 Range
• Exceeds IEC 62053/ANSI C12.20 Standards
• Seven Sensor Inputs with Neutral Current
Measurement
• Low-Jitter Wh and VARh Plus Two Additional
Pulse Test Outputs (4 Total, 10kHz max) with
Pulse Count
The 71M6533 and 71M6534 add several new features to the
Teridian flagship 71M6513 polyphase meters, including an SPI
interface, advanced power management with < 1µA sleep current,
4KB shared RAM, and 128KB (71M6533/H, 71M6534), or 256KB
(71M6533G, 71M6534H) flash, which can be programmed in the
field with new code and/or data during meter operation. Higher
processing and sampling rates and larger memory offer a
powerful metering platform for commercial and industrial meters
with up to class 0.2 accuracy.
A complete array of ICE and development tools, programming
libraries and reference designs enable rapid development and
certification of meters that meet all ANSI and IEC electricity metering
standards worldwide.
CT/ COIL
LIVE
NEUT
LOAD
LIVE
LIVE
• Four-Quadrant Metering
• Phase Sequencing
• Line Frequency Count for RTC
• Digital Temperature Compensation
• Independent 32-Bit CE
• 46-64 Hz Line Frequency Range with Same
Calibration; Phase Compensation (± 7°)
• Three Battery-Backup Modes with Wake-Up
on Timer or Pushbutton:
Brownout Mode (82µA typ, 71M6533)
LCD Mode (21µA typ, DAC active)
Sleep Mode (0.7µA typ)
• Energy Display During Mains Power Failure
• 39mW (typ) Consumption at 3.3V, MPU
Clock Frequency 614kHz
• 8-Bit MPU (80515), 10MHz (max), One
Clock Cycle per Instruction with Integrated
ICE for Debug
POWER SUPPLY
• LCD Driver with Four Common Segment
NEUTRAL
Drivers:
Up to 228 Pixels (71M6533) or 300 Pixels
CONVERTER
IA
VA
V3P3A V3P3SYS GNDA GNDD
PWR MODE
CONTROL
(71M6534)
• Four Dedicated + 35 (71M6533) or 48
IB
TERIDIAN WAKE-up
VB
71M6533 _REGULATOR
IC
71M6534
VBAT
VC
V2P5
BATTERY
(71M6534) Multifunction DIO Pins
• RTC for TOU Functions with Clock-Rate Adjust
Register
ID
TEMP
LCD DRIVER
SENSOR
DIO ,PULSE
• Hardware Watchdog Timer, Power-Fail Monitor
AMR
IR
POWER
FAULT
VREF
SERIAL PORTS
TX
RX
RX
MOD _TX
COMPARATOR
V1
RAM
COMPUTE
ENGINE
FLASH
MPU
RTC
TIMERS
V2*
ICE
COM0..3
SEG
SEG/ DIO
DIO
OSC/ PLL
XIN
XOUT
• I²C/MICROWIRE® EEPROM Interface
8888.8888 _{• High-Speed Slave SPI Interface to Data RAM}
PULSES,
DIO
I²C or µWire
EEPROM
32 kHz
• Two UARTs for IR and AMR, IR Driver with
Modulation
• Flash Memory with Security and In-System
Program Update:
128KB (71M6533/H, 71M6534)
256KB (71M6533G, 71M6534H)
• 4KB RAM
* 71M6534 only
9/24/2008
Teridian is a trademark and Single Converter Technology is a registered
• Industrial Temperature Range
trademark of Maxim Integrated Products, Inc.
• 100-Pin (71M6533/G/H) or 120-Pin
MICROWIRE is a registered trademark of National Semiconductor Corp.
(71M6534/H) Lead(Pb)-Free LQFP Package
Rev 2
1