5968-4632E Datasheet, PDF (8/77 Pages) Keysight Technologies – Probing Solutions for Logic Analyzers

08 | Keysight | Probing Solutions for Logic Analyzers - Data Sheet
Probe Selection Guide for All Keysight Logic Analyzers (Continued)
40-pin probes selection guide
Compatible with Keysight models 16910A/11A, 16800 Series, 16750/51/52A/B, 1674X Series, 1671x Series, 165xx Series modules,
1690 Series, 1680 Series, 1670 Series, 1660 Series, 1650 Series, and E9340 logic analyzers.
Model number
Application
Number of
channels
Supported signal
types
Maximum data
rate
Soft touch connectorless probes
Supplied with five retention modules
E5396A
E5404A
E5394A
Quick connection to many channels in a small footprint without a
header designed into the target system
17
34
34
16 data, 1 clock
32 data, 2 clock 32 data, 2 clock
All probes: single-ended clock, single-ended data
Samtec probe
E5385A
Quick connection
to many signals in a
small footprint
34
32 data, 2 clock
> 2.5 Gb/s
> 2.5 Gb/s
> 2.5 Gb/s
1.5 Gb/s
Minimum signal
amplitude
Connection to
target system
500 mV p-p
500 mV p-p
500 mV p-p
500 mV p-p
Requires half-size
soft touch footprint
designed into the
target
Requires Pro
Series soft touch
footprint designed
into the target
Requires original
soft touch footprint
designed into the
target
Requires 100-pin
Samtec connector
designed into the
target system
Input capacitance < 0.7 pF
Additional supplies Additional five
retention modules
Orderable as
Order kit
E5396-68702
< 0.7 pF
Additional five
retention modules
< 0.7 pF
Additional five
retention modules
Order kit E5403A Order kit
E5387-68701
1.5 pF
See Table 1 for PC
board connectors
and shrouds
Mictor probe
E5346A
Quick connection
to many signals in a
small footprint
34
32 data, 2 clock
General purpose
flying lead set
E5383A
Flexible connection
to individual
signals
17
16 data, 1 clock
Equivalent to the
logic analyzer data
rate the probe is
attached to
500 mV p-p ¹
Equivalent to the
logic analyzer data
rate the probe is
attached to
600 mV p-p
Requires 38-pin
Mictor connector
designed into the
target system ²
3.0 pF
See Table 1 for pc
board connectors
and shrouds
Compatible with a
wide assortment
of accessories
to connect to
individual leads
1.5 pF
See Figure for
additional leads
and grabbers
1. Model E5339A low voltage Mictor probe = 250 mV p-p
2. Model E5351A Unterminated Mictor probe requires isolation networks to be provided on the target system. See page 64 for details.