5968-4632E Datasheet, PDF (18/77 Pages) Keysight Technologies – Probing Solutions for Logic Analyzers

18 | Keysight | Probing Solutions for Logic Analyzers - Data Sheet
Probing Solutions for 90-pin Logic Analyzers
Soft Touch Connectorless Probing (Continued)
E5405B Differential Pro series soft touch connectorless probe
The E5405B is a 17-channel differential Pro Series soft touch connectorless probe
compatible with all Keysight logic analyzers that have a 90-pin pod connector. It is
capable of acquiring data at the maximum rates of the logic analyzer it is connected to.
Features
– No connector on the target board
– Top-side retention module
– Industry-standard connectorless footprint
– 17 channels, differential or single-ended clock and data
– Extremely low, < 0.7 pF, equivalent load capacitance
– Capable of data rates of 4 Gb/s (maximum rate dependent on analyzer used)
– 200 mV Vmax–Vmin minimum signal amplitude
– Robust and reliable soft touch technology
Unused clock inputs can be used as data inputs.
The E5405B uses the same retention module as the E5404A and E5406A Pro Series soft
touch connectorless probe.
A kit of five retention modules is shipped with each Pro Series soft touch probe.
Additional kits can be ordered using Keysight part number E5403A.
E5406A/E5402A Pro Series soft touch connectorless probes
The E53406A/E5402A are 34-channel single-ended Pro Series soft touch connectorless
probe compatible with all Keysight logic analyzers that have a 90-pin pod connector.
The E5402A is a low profile right angle version of the E5406A probe.
Features
– No connector on the target board
– Top-side mount retention module
– Industry-standard connectorless footprint
– 34 channels, single-ended or differential clock and single-ended data
– Extremely low, < 0.7 pF, equivalent load capacitance
– Capable of data rates of 4 Gb/s (maximum rate dependent on analyzer used)
– 250 mV p-p minimum signal amplitude
– Robust and reliable soft touch technology
Unused clock inputs can be used as data inputs.
The E5406A (used with logic analyzers with a 90-pin cable connector) uses the same
footprint, pinout, and retention module as the E5404A and E5402A Pro Series soft touch
connectorless probes (used with logic analyzers with a 40-pin cable connector).
A kit of five retention modules is shipped with each Pro Series soft touch probe.
Additional kits can be ordered using Keysight part number E5403A. The low profile
E5402A probe uses retention module Keysight part number E5412A.