5968-4632E Datasheet, PDF (35/77 Pages) Keysight Technologies – Probing Solutions for Logic Analyzers

35 | Keysight | Probing Solutions for Logic Analyzers - Data Sheet
Probing Solutions for 90-pin Logic Analyzers
Mictor and Samtec Probing (Continued)
E5380B 38-pin probe
The E5380B is designed to be compatible with the Mictor connector. If you have a target
system designed for connection to the E5346A high-density probe adapter, the E5380B
probe will connect directly to this same Mictor connector. (For information on the
E5346A, refer to pages 62 to 64). The maximum state speed when used with the E5380B
probe is 600 Mbits/second. The minimum input signal amplitude required by the E5380B
is 300 mV.
The E5380B probe combines two 17-channel cables into a single-ended 38-pin Mictor
connector.
Refer to Table 4 for connector, shroud, and kit part numbers.
38-pin probe
Probing connector Kit
Shrouds (5)
38-pin connectors (5)
See Table 4 for part numbers
Figure 4.29. Keysight E5380B probe.
Table 4. Mating connectors, shrouds, and kits for Keysight E5378A,
E5379A, and E5380B probes
For probe model
numbers
E5378A, E5379A
E5380B
Description
Kit of 5 support shrouds and 5 100-pin Samtec connectors
for PC board thickness up to 1.57 mm (0.062”)
Kit of 5 support shrouds and 5 100-pin Samtec connectors
for PC board thickness up to 3.05 mm (0.120”)
One 100-pin Samtec connector (also available from Samtec
as part number ASP-65067-01)
One support shroud for PC board thickness up to 1.57 mm
(0.062”)
One support shroud for PC board thickness up to 3.05 mm
(0.120”)
Kit of 5 support shrouds and 5 38-pin Mictor connectors for
PC board thickness up to 1.57 mm (0.062”)
Kit of 5 support shrouds and 5 38-pin Mictor connectors for
PC board thickness up to 3.175 mm (0.125”)
One 38-pin Mictor connector (also available from AMP as
part number 2-767004-2)
One support shroud for PC board thickness up to 1.57 mm
(0.062”)
One support shroud for PC board thickness up to 3.175 mm
(0.125”)
One support shroud for PC board thickness up to 4.318 mm
(0.700”)
Keysight part
number
16760-68702
16760-68703
1253-3620
16760-02302
16760-02303
E5346-68701
E5346-68700
1252-7431
E5346-44701
E5346-44704
E5346-44703
For further information on designing the E5378A, E5379A, or E5380B probe connectors into your system, refer to the following
documents:
Keysight Logic Analyzer Probes
(E5378A, E5379A, E5380B, and
E5386A) User’s Guide
Mechanical drawings, electrical models,
general information on probes for logic
analyzers with 90-pin connectors
16760-97016
http://literature.cdn.keysight.com/litweb/pdf/16760-97016.pdf
Designing High-Speed Digital Systems Design recommendations, examples, and 5988-2989EN
for Logic Analyzer Probing
analysis for layout of target systems
http://literature.cdn.keysight.com/litweb/pdf/5988-2989EN.pdf