BX80547PG3200FSL8Q6 Datasheet, PDF (94/105 Pages) Intel Corporation – Intel® Pentium® 4 Processor 6xxΔ Sequence and Intel® Pentium® 4 Processor Extreme Edition

Boxed Processor Specifications
The boxed processor's fan heatsink requires a constant +12 V supplied to pin 2 and does not
support variable voltage control or 3-pin PWM control.
The power header on the baseboard must be positioned to allow the fan heatsink power cable to
reach it. The power header identification and location should be documented in the platform
documentation, or on the system board itself. Figure 7-6 shows the location of the fan power
connector relative to the processor socket. The baseboard power header should be positioned
within 110 mm [4.33 inches] from the center of the processor socket.
Figure 7-5. Boxed Processor Fan Heatsink Power Cable Connector Description
Pin Signal
1 GND
2 +12 V
3 SENSE
4 CONTROL
Straight square pin, 4-pin terminal housing with
polarizing ribs and friction locking ramp.
0.100" pitch, 0.025" square pin width.
Match with straight pin, friction lock header on
mainboard.
12 34
Table 7-1. Fan Heatsink Power and Signal Specifications
Description
Min
+12 V: 12 volt fan power supply
10.2
IC:
• Peak Fan current draw
—
• Fan start-up current draw
—
• Fan start-up current draw maximum duration
—
SENSE: SENSE frequency
—
CONTROL
21
NOTES:
1. Baseboard should pull this pin up to 5 V with a resistor.
2. Open drain type, pulse width modulated.
3. Fan will have pull-up resistor to 4.75 V maximum of 5.25 V.
Typ Max
12
13.8
Unit
Notes
V
—
1.1
1.5
A
—
—
2.2
A
—
1.0
Second
2
—
pulses per fan
revolution
1
25
28
kHz
2, 3
Figure 7-6. Baseboard Power Header Placement Relative to Processor Socket
R110
[4.33]
B
C
94
Datasheet